This patch enables the PCIe2 on the CM4IO board when paired with a SOQuartz CM4 System-on-Module board. combphy2 also needs to be enabled in this case to make the PHY work for this. Signed-off-by: Nicolas Frattaroli <frattaroli.nicolas@xxxxxxxxx> --- .../boot/dts/rockchip/rk3566-soquartz-cm4.dts | 11 +++++++++++ arch/arm64/boot/dts/rockchip/rk3566-soquartz.dtsi | 15 +++++++++++++++ 2 files changed, 26 insertions(+) diff --git a/arch/arm64/boot/dts/rockchip/rk3566-soquartz-cm4.dts b/arch/arm64/boot/dts/rockchip/rk3566-soquartz-cm4.dts index e00568a6be5c..263ce40770dd 100644 --- a/arch/arm64/boot/dts/rockchip/rk3566-soquartz-cm4.dts +++ b/arch/arm64/boot/dts/rockchip/rk3566-soquartz-cm4.dts @@ -30,6 +30,12 @@ vcc_5v: vcc-5v-regulator { }; }; +/* phy for pcie */ +&combphy2 { + phy-supply = <&vcc3v3_sys>; + status = "okay"; +}; + &gmac1 { status = "okay"; }; @@ -105,6 +111,11 @@ &led_work { status = "okay"; }; +&pcie2x1 { + vpcie3v3-supply = <&vcc_3v3>; + status = "okay"; +}; + &rgmii_phy1 { status = "okay"; }; diff --git a/arch/arm64/boot/dts/rockchip/rk3566-soquartz.dtsi b/arch/arm64/boot/dts/rockchip/rk3566-soquartz.dtsi index 1b975822effa..ce7165d7f1a1 100644 --- a/arch/arm64/boot/dts/rockchip/rk3566-soquartz.dtsi +++ b/arch/arm64/boot/dts/rockchip/rk3566-soquartz.dtsi @@ -487,6 +487,12 @@ rgmii_phy1: ethernet-phy@0 { }; }; +&pcie2x1 { + pinctrl-names = "default"; + pinctrl-0 = <&pcie_reset_h>; + reset-gpios = <&gpio1 RK_PB2 GPIO_ACTIVE_HIGH>; +}; + &pinctrl { bt { bt_enable_h: bt-enable-h { @@ -512,6 +518,15 @@ diy_led_enable_h: diy-led-enable-h { }; }; + pcie { + pcie_clkreq_h: pcie-clkreq-h { + rockchip,pins = <1 RK_PB0 RK_FUNC_GPIO &pcfg_pull_none>; + }; + pcie_reset_h: pcie-reset-h { + rockchip,pins = <1 RK_PB2 RK_FUNC_GPIO &pcfg_pull_none>; + }; + }; + pmic { pmic_int_l: pmic-int-l { rockchip,pins = <0 RK_PA3 RK_FUNC_GPIO &pcfg_pull_up>; -- 2.38.1