On Thu, 3 Nov 2022 15:00:28 +0200 Cosmin Tanislav <demonsingur@xxxxxxxxx> wrote: > Add support for the following parts: > * LTC2984 > * LTC2986 > * LTM2985 > > The LTC2984 is a variant of the LTC2983 with EEPROM. > The LTC2986 is a variant of the LTC2983 with only 10 channels, > EEPROM and support for active analog temperature sensors. > The LTM2985 is software-compatible with the LTC2986. > > Also, make bulk write buffer DMA-safe. > Besides that, refine the binding. Replying at least partly so I can see I already looked at this... Looks good to me. Will pick up once DT bindings maintainers are happy. Thanks, Jonathan > > V1 -> V2: > * add Fixes tag > * add patch that fixes the regmap_bulk_write() call with stack allocated > buffer > * add patch that refines the binding in preperation for adding new > parts support to it > * do not use stack allocated buffer for writing the EEPROM key > > V2 -> V3: > * drop minItems if equal to maxItems > * drop adi,single-ended conditions because of recent dtschema > restrictions (even though they're valid in jsonschema and the last > dtschema tag) > * drop "allocate iio channels once" patch since it's been picked as a fix > > V3 -> V4: > * add pipe for 'adi,mux-delay-config-us' description > * add pipe for 'adi,rtd-curve' description > * keep newlines after descriptions > * move 'adi,current-rotate' to conditional > * put 'adi,custom-steinhart' in the original place > * keep 'minItems' for 'adi,custom-steinhart' > * override 'enum' to forbid auto-range in 'adi,excitation-current-nanoamp' > when using custom thermistors > * split refine patch into multiple patches > - use generic node name in example > - describe broken mux delay property > - refine descriptions > - change default excitation for custom thermistors > - require 4 wire rtd for current rotate > - require custom sensor tables > - describe matrix items > - remove qutations from phandle ref > - use hex for sensor address > - add default values > > Cosmin Tanislav (13): > iio: temperature: ltc2983: make bulk write buffer DMA-safe > dt-bindings: iio: temperature: ltc2983: add default values > dt-bindings: iio: temperature: ltc2983: use hex for sensor address > dt-bindings: iio: temperature: ltc2983: remove qutations from phandle > ref > dt-bindings: iio: temperature: ltc2983: describe matrix items > dt-bindings: iio: temperature: ltc2983: require custom sensor tables > dt-bindings: iio: temperature: ltc2983: require 4 wire rtd for current > rotate > dt-bindings: iio: temperature: ltc2983: change default excitation for > custom thermistors > dt-bindings: iio: temperature: ltc2983: refine descriptions > dt-bindings: iio: temperature: ltc2983: describe broken mux delay > property > dt-bindings: iio: temperature: ltc2983: use generic node name in > example > dt-bindings: iio: temperature: ltc2983: support more parts > iio: temperature: ltc2983: support more parts > > .../bindings/iio/temperature/adi,ltc2983.yaml | 335 +++++++++++------- > drivers/iio/temperature/ltc2983.c | 193 +++++++++- > 2 files changed, 389 insertions(+), 139 deletions(-) >
