From: Benedikt Niedermayr <benedikt.niedermayr@xxxxxxxxxxx>
The GPMC controller has the ability to configure the polarity for the
wait pin. The current properties do not allow this configuration.
This binding directly configures the WAITPIN<X>POLARITY bit
in the GPMC_CONFIG register by setting the "ti,wait-pin-polarity"
dt-property.
Signed-off-by: Benedikt Niedermayr <benedikt.niedermayr@xxxxxxxxxxx>
Reviewed-by: Rob Herring <robh@xxxxxxxxxx>
---
.../bindings/memory-controllers/ti,gpmc-child.yaml | 7 +++++++
1 file changed, 7 insertions(+)
diff --git a/Documentation/devicetree/bindings/memory-controllers/ti,gpmc-child.yaml b/Documentation/devicetree/bindings/memory-controllers/ti,gpmc-child.yaml
index 6e3995bb1630..4a257fac577e 100644
--- a/Documentation/devicetree/bindings/memory-controllers/ti,gpmc-child.yaml
+++ b/Documentation/devicetree/bindings/memory-controllers/ti,gpmc-child.yaml
@@ -230,6 +230,13 @@ properties:
Wait-pin used by client. Must be less than "gpmc,num-waitpins".
$ref: /schemas/types.yaml#/definitions/uint32
+ ti,wait-pin-polarity:
+ description: |
+ Set the desired polarity for the selected wait pin.
+ 0 for active low, 1 for active high.
+ $ref: /schemas/types.yaml#/definitions/uint32
+ enum: [0, 1]
+
gpmc,wait-on-read:
description: Enables wait monitoring on reads.
type: boolean
--
2.25.1
