On Wed, 12 Oct 2022 16:05:23 -0700, Stephen Boyd wrote: > Quoting Emil Renner Berthing (2022-10-05 06:14:44) > > > > @@ -295,11 +296,13 @@ static int __init clk_starfive_jh7100_probe(struct platform_device *pdev) > > > > if (!priv) > > > > return -ENOMEM; > > > > > > > > - spin_lock_init(&priv->rmw_lock); > > > > priv->dev = &pdev->dev; > > > > - priv->base = devm_platform_ioremap_resource(pdev, 0); > > > > - if (IS_ERR(priv->base)) > > > > - return PTR_ERR(priv->base); > > > > + priv->regmap = device_node_to_regmap(priv->dev->of_node); > > > > > > This is sad. Why do we need to make a syscon? Can we instead use the > > > auxiliary bus to make a reset device that either gets a regmap made here > > > in this driver or uses a void __iomem * mapped with ioremap > > > (priv->base)? > > > > In my original code the clock driver just registers the resets too > > similar to other combined clock and reset drivers. I wonder what you > > think about that approach: > > https://github.com/esmil/linux/commit/36f15e1b827b02d7f493dc5fce31060b21976e68 > > and > > https://github.com/esmil/linux/commit/4ccafadb72968480aa3dd28c227fcccae411c13b#diff-ffec81f902f810cb210012c25e8d88217ea5b4021419a4206d1fd4dd19edfce8R471 > > I think we should use auxiliary bus and split the driver logically into > a reset driver in drivers/reset and a clk driver in drivers/clk. That > way the appropriate maintainers can review the code. There is only one > platform device with a single reg property and node in DT, but there are > two drivers. Yes, I agree that the reset driver and the clock driver should be split. However, I think using auxiliary bus is a little bit complicated in this case, because the reset is not a part of functionality of the clock in JH7110. They just share a common register base address. I think it is better to use ioremap for the same address, and the dt will be like syscrg_clk: clock-controller@13020000 { compatible = "starfive,jh7110-clkgen-sys"; reg = <0x0 0x13020000 0x0 0x10000>; ... }; syscrg_rst: reset-controller@13020000 { compatible = "starfive,jh7110-reset-sys"; reg = <0x0 0x13020000 0x0 0x10000>; ... }; What do you think of this approach? I would appreciate your suggestions. Best regards, Hal
