Hi, This series aims to improve the power level switching between standard level 1 and the higher power levels. The first patch updates the DT binding documentation to include the minimum and default of 1W, which is the base level that every SFP cage must support. Hence, it makes sense to document this in the binding. The second patch enforces a minimum of 1W when parsing the firmware description, and optimises the code for that case; there's no need to check for SFF8472 compliance since we will not need to touch the A2h registers. Patch 3 validates that the module supports SFF-8472 rev 10.2 before checking for power level 2 - rev 10.2 is where support for power levels was introduced, so if the module doesn't support this revision, it doesn't support power levels. Setting the power level 2 declaration bit is likely to be spurious. Patch 4 does the same for power level 3, except this was introduced in SFF-8472 rev 11.9. The revision code was never updated, so we use the rev 11.4 to signify this. Patch 5 cleans up the code - rather than using BIT(0), we now use a properly named value for the power level select bit. Patch 6 introduces a read-modify-write helper. Patch 7 gets rid of the DM7052 hack (which sets a power level declaration bit but is not compatible with SFF-8472 rev 10.2, and the module does not implement the A2h I2C address.) Series tested with my DM7052. Documentation/devicetree/bindings/net/sff,sfp.yaml | 2 + drivers/net/phy/sfp.c | 85 +++++++++++----------- include/linux/sfp.h | 2 + 3 files changed, 48 insertions(+), 41 deletions(-) -- RMK's Patch system: https://www.armlinux.org.uk/developer/patches/ FTTP is here! 40Mbps down 10Mbps up. Decent connectivity at last!