Shawn, will you take this series? Thanks Sascha On Thu, Sep 22, 2022 at 10:13:44AM +0200, Sascha Hauer wrote: > The InnoComm WB15-EVK [1] board is a Eval base board for the WB15 SoM > [2] which is based on the NXP i.MX8MM. This series adds InnoComm as a > vendor prefix and the necessary dts/dtsi files. > [1] https://www.innocomm.com/product_inner.aspx?num=2233 > [2] https://www.innocomm.com/product_inner.aspx?num=2232 > > Changes since v3: > - drop unnecessary status = "okay" from new node > > Changes since v2: > - Fix another remaining s/innocom/innocomm/ > - Don't use underscores in node names > - Use IRQ_TYPE_LEVEL_LOW to specify interrupt polarity > > Changes since v1: > - Fix spelling of InnoComm: > s/innocom/innocomm/ > s/Innocom/InnoComm/ > > Sascha Hauer (3): > dt-bindings: vendor-prefixes: Add prefix for InnoComm > dt-bindings: arm: fsl: Add InnoComm WB15 EVK > arm64: dts: freescale: Add InnoComm i.MX8MM based WB15 SoM and EVK > > .../devicetree/bindings/arm/fsl.yaml | 1 + > .../devicetree/bindings/vendor-prefixes.yaml | 2 + > arch/arm64/boot/dts/freescale/Makefile | 1 + > .../freescale/imx8mm-innocomm-wb15-evk.dts | 146 ++++++ > .../dts/freescale/imx8mm-innocomm-wb15.dtsi | 480 ++++++++++++++++++ > 5 files changed, 630 insertions(+) > create mode 100644 arch/arm64/boot/dts/freescale/imx8mm-innocomm-wb15-evk.dts > create mode 100644 arch/arm64/boot/dts/freescale/imx8mm-innocomm-wb15.dtsi > > -- > 2.30.2 > > -- Pengutronix e.K. | | Steuerwalder Str. 21 | http://www.pengutronix.de/ | 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 |
