Add thermal driver for Sunplus.
Signed-off-by: Li-hao Kuo <lhjeff911@xxxxxxxxx>
---
Changes in v11:
- Remove the remove function of the platform_driver
- Fix error reported-by: kernel test robot.
MAINTAINERS | 6 ++
drivers/thermal/Kconfig | 10 +++
drivers/thermal/Makefile | 1 +
drivers/thermal/sunplus_thermal.c | 130 ++++++++++++++++++++++++++++++++++++++
4 files changed, 147 insertions(+)
create mode 100644 drivers/thermal/sunplus_thermal.c
diff --git a/MAINTAINERS b/MAINTAINERS
index cf0f185..bf22c53 100644
--- a/MAINTAINERS
+++ b/MAINTAINERS
@@ -19753,6 +19753,12 @@ S: Maintained
F: Documentation/devicetree/bindings/spi/spi-sunplus-sp7021.yaml
F: drivers/spi/spi-sunplus-sp7021.c
+SUNPLUS THERMAL DRIVER
+M: Li-hao Kuo <lhjeff911@xxxxxxxxx>
+L: linux-pm@xxxxxxxxxxxxxxx
+S: Maintained
+F: drivers/thermal/sunplus_thermal.c
+
SUNPLUS UART DRIVER
M: Hammer Hsieh <hammerh0314@xxxxxxxxx>
S: Maintained
diff --git a/drivers/thermal/Kconfig b/drivers/thermal/Kconfig
index e052dae..405b788 100644
--- a/drivers/thermal/Kconfig
+++ b/drivers/thermal/Kconfig
@@ -504,4 +504,14 @@ config KHADAS_MCU_FAN_THERMAL
If you say yes here you get support for the FAN controlled
by the Microcontroller found on the Khadas VIM boards.
+config SUNPLUS_THERMAL
+ tristate "Sunplus thermal drivers"
+ depends on SOC_SP7021 || COMPILE_TEST
+ help
+ This enable the Sunplus SP7021 thermal driver, which supports the primitive
+ temperature sensor embedded in Sunplus SP7021 SoC.
+
+ If you have a Sunplus SP7021 platform say Y here and enable this option
+ to have support for thermal management.
+
endif
diff --git a/drivers/thermal/Makefile b/drivers/thermal/Makefile
index 2506c6c..4512193 100644
--- a/drivers/thermal/Makefile
+++ b/drivers/thermal/Makefile
@@ -61,3 +61,4 @@ obj-$(CONFIG_UNIPHIER_THERMAL) += uniphier_thermal.o
obj-$(CONFIG_AMLOGIC_THERMAL) += amlogic_thermal.o
obj-$(CONFIG_SPRD_THERMAL) += sprd_thermal.o
obj-$(CONFIG_KHADAS_MCU_FAN_THERMAL) += khadas_mcu_fan.o
+obj-$(CONFIG_SUNPLUS_THERMAL) += sunplus_thermal.o
\ No newline at end of file
diff --git a/drivers/thermal/sunplus_thermal.c b/drivers/thermal/sunplus_thermal.c
new file mode 100644
index 0000000..20ea7d9
--- /dev/null
+++ b/drivers/thermal/sunplus_thermal.c
@@ -0,0 +1,130 @@
+// SPDX-License-Identifier: GPL-2.0-only
+/*
+ * Copyright (c) Sunplus Inc.
+ * Author: Li-hao Kuo <lhjeff911@xxxxxxxxx>
+ */
+
+#include <linux/bitfield.h>
+#include <linux/clk.h>
+#include <linux/delay.h>
+#include <linux/io.h>
+#include <linux/module.h>
+#include <linux/nvmem-consumer.h>
+#include <linux/platform_device.h>
+#include <linux/reset.h>
+#include <linux/thermal.h>
+
+#define ENABLE_THERMAL BIT(31)
+#define SP_THERMAL_MASK GENMASK(10, 0)
+
+#define TEMP_RATE 608
+#define TEMP_BASE 3500
+#define TEMP_OTP_BASE 1518
+
+#define SP_THERMAL_CTL0_REG 0x0000
+#define SP_THERMAL_STS0_REG 0x0030
+
+/* common data structures */
+struct sp_thermal_data {
+ struct thermal_zone_device *pcb_tz;
+ void __iomem *regs;
+ int *otp_temp0;
+};
+
+static int sunplus_get_otp_temp_coef(struct sp_thermal_data *sp_data, struct device *dev)
+{
+ struct nvmem_cell *cell;
+ ssize_t otp_l;
+
+ cell = nvmem_cell_get(dev, "calib");
+ if (IS_ERR(cell))
+ return PTR_ERR(cell);
+
+ sp_data->otp_temp0 = nvmem_cell_read(cell, &otp_l);
+ nvmem_cell_put(cell);
+
+ if (*sp_data->otp_temp0 == 0)
+ *sp_data->otp_temp0 = TEMP_OTP_BASE;
+
+ return 0;
+}
+
+/*
+ * There is a thermal sensor instance for Sunplus Soc
+ * T_CODE is the ADC of the thermal sensor
+ * T_CODE : 11 digits in total
+ * When remanufacturing, the 35 degree T_CODE will be read and stored in nvcell.
+ * otp_temp0 is the 35 degree T_CODE obtained from nvcell
+ * The function will get 35 degree T_CODE for thermal calibration.
+ * TEMP_RATE is the Sunplus thermal temperature slope.
+ */
+
+static int sp_thermal_get_sensor_temp(void *data, int *temp)
+{
+ struct sp_thermal_data *sp_data = data;
+ int t_code;
+
+ t_code = readl(sp_data->regs + SP_THERMAL_STS0_REG);
+ t_code = FIELD_GET(SP_THERMAL_MASK, t_code);
+ *temp = ((*sp_data->otp_temp0 - t_code) * 10000 / TEMP_RATE) + TEMP_BASE;
+ *temp *= 10;
+ return 0;
+}
+
+static const struct thermal_zone_of_device_ops sp_of_thermal_ops = {
+ .get_temp = sp_thermal_get_sensor_temp,
+};
+
+static int sunplus_thermal_probe(struct platform_device *pdev)
+{
+ struct sp_thermal_data *sp_data;
+ int ret;
+
+ sp_data = devm_kzalloc(&pdev->dev, sizeof(*sp_data), GFP_KERNEL);
+ if (!sp_data)
+ return -ENOMEM;
+
+ sp_data->regs = devm_platform_ioremap_resource(pdev, 0);
+ if (IS_ERR(sp_data->regs)) {
+ dev_err(&pdev->dev, "resource get fail\n");
+ return PTR_ERR(sp_data->regs);
+ }
+
+ writel(ENABLE_THERMAL, sp_data->regs + SP_THERMAL_CTL0_REG);
+
+ platform_set_drvdata(pdev, sp_data);
+ ret = sunplus_get_otp_temp_coef(sp_data, &pdev->dev);
+ if (ret)
+ return ret;
+
+ sp_data->pcb_tz = devm_thermal_zone_of_sensor_register(&pdev->dev,
+ 0,
+ sp_data, &sp_of_thermal_ops);
+
+ if (IS_ERR(sp_data->pcb_tz)) {
+ ret = PTR_ERR(sp_data->pcb_tz);
+ dev_err(&pdev->dev, "failed to register tsensor: %d\n", ret);
+ return ret;
+ }
+
+ return ret;
+}
+
+static const struct of_device_id of_sunplus_thermal_ids[] = {
+ { .compatible = "sunplus,sp7021-thermal" },
+ { /* sentinel */ }
+};
+MODULE_DEVICE_TABLE(of, of_sunplus_thermal_ids);
+
+static struct platform_driver sunplus_thermal_driver = {
+ .probe = sunplus_thermal_probe,
+ .driver = {
+ .name = "sunplus-thermal",
+ .of_match_table = of_sunplus_thermal_ids,
+ },
+};
+module_platform_driver(sunplus_thermal_driver);
+
+MODULE_AUTHOR("Li-hao Kuo <lhjeff911@xxxxxxxxx>");
+MODULE_DESCRIPTION("Thermal driver for Sunplus SoC");
+MODULE_LICENSE("GPL");
--
2.7.4
