Add support for USBPHYC, USB Host and USB OTG on STM32MP13. Enable all these interfaces on STM32MP135F-DK board. Enable the STM32G0 UCSI driver as module. Dependency on PWR and PMIC regulator is tempoarily managed by using fixed regulators (resp in the SoC dtsi and the board dts files). The USB support is functional when these regulators gets enabled at boot time before entering the kernel. Amelie Delaunay (5): ARM: dts: stm32: add USBPHYC and dual USB HS PHY support on stm32mp131 ARM: dts: stm32: add UBSH EHCI and OHCI support on stm32mp131 ARM: dts: stm32: add USB OTG HS support on stm32mp131 ARM: dts: stm32: enable USB HS phys on stm32mp135f-dk ARM: dts: stm32: enable USB Host EHCI on stm32mp135f-dk Fabrice Gasnier (5): ARM: dts: stm32: add PWR fixed regulators on stm32mp131 ARM: dts: stm32: add fixed regulators to support usb on stm32mp135f-dk ARM: dts: stm32: add pins for stm32g0 typec controller on stm32mp13 ARM: dts: stm32: enable USB OTG in dual role mode on stm32mp135f-dk ARM: multi_v7_defconfig: enable Type-C UCSI and STM32G0 as modules arch/arm/boot/dts/stm32mp13-pinctrl.dtsi | 7 ++ arch/arm/boot/dts/stm32mp131.dtsi | 81 ++++++++++++++++++++ arch/arm/boot/dts/stm32mp135f-dk.dts | 95 ++++++++++++++++++++++++ arch/arm/configs/multi_v7_defconfig | 2 + 4 files changed, 185 insertions(+) -- 2.25.1
