The Trogdor Homestar DTSI adds additional GPIO52 pin to secondary I2S pins
("sec_mi2s_active") and configures it to "mi2s_1" function.
The Trogdor DTSI (which is included by Homestar) configures drive
strength and bias for all "sec_mi2s_active" pins, thus the intention was
to apply this configuration also to GPIO52 on Homestar.
Reported-by: Doug Anderson <dianders@xxxxxxxxxxxx>
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
---
Changes since v1:
1. New patch
Not tested on hardware.
Cc: Doug Anderson <dianders@xxxxxxxxxxxx>
---
arch/arm64/boot/dts/qcom/sc7180-trogdor-homestar.dtsi | 6 ++++++
1 file changed, 6 insertions(+)
diff --git a/arch/arm64/boot/dts/qcom/sc7180-trogdor-homestar.dtsi b/arch/arm64/boot/dts/qcom/sc7180-trogdor-homestar.dtsi
index 1bd6c7dcd9e9..bfab67f4a7c9 100644
--- a/arch/arm64/boot/dts/qcom/sc7180-trogdor-homestar.dtsi
+++ b/arch/arm64/boot/dts/qcom/sc7180-trogdor-homestar.dtsi
@@ -194,6 +194,12 @@ pinmux {
pins = "gpio49", "gpio50", "gpio51", "gpio52";
function = "mi2s_1";
};
+
+ pinconf {
+ pins = "gpio49", "gpio50", "gpio51", "gpio52";
+ drive-strength = <2>;
+ bias-pull-down;
+ };
};
&ts_reset_l {
--
2.34.1
