Hey Uwe, all, ~6.0-rc1 has rolled around so here is the promised v8v9~. v11 is based on 6.0 stuff still & there will be a change to the dts patch in v6.1, but I did a test merge and there was nothing to resolve. I'll take the dts change myself just to be on the safe side. The pre 6.0-rc1 cover letter/series is here: https://lore.kernel.org/linux-pwm/20220721172109.941900-1-mail@xxxxxxxxxxx Thanks, Conor. Changes since v10: - reword some comments - try to assign the period if a disable is requested - drop a cast around a u8 -> u16 conversion - fix a check on period_steps that should be on the hw_ variant - split up the period calculation in get_state() to fix the result on 32 bit - add a rate variable in get_state() to only call get_rate() once. - redo the locking as suggested to make it more straightforward. - stop checking for enablement in get_state() that was working around intended behaviour of the sysfs interface Changes since v9: - fixed the missing unlock that Dan reported Changes since v8: - fixed a(nother) raw 64 bit division (& built it for riscv32!) - added a check to make sure we don't try to sleep for 0 us Changes since v7: - rebased on 6.0-rc1 - reworded comments you highlighted in v7 - fixed the overkill sleeping - removed the unused variables in calc_duty - added some extra comments to explain behaviours you questioned in v7 - make the mutexes un-interruptible - fixed added the 1s you suggested for the if(period_locked) logic - added setup of the channel_enabled shadowing - fixed the period reporting for the negedge == posedge case in get_state() I had to add the enabled check, as otherwise it broke setting the period for the first time out of reset. - added a test for invalid PERIOD_STEPS values, in which case we abort if we cannot fix the period Changes from v6: - Dropped an unused variable that I'd missed - Actually check the return values of the mutex lock()s - Re-rebased on -next for the MAINTAINERS patch (again...) Changes from v5: - switched to a mutex b/c we must sleep with the lock taken - simplified the locking in apply() and added locking to get_state() - reworked apply() as requested - removed the loop in the period calculation (thanks Uwe!) - add a copy of the enable registers in the driver to save on reads. - remove the second (useless) write to sync_update - added some missing rounding in get_state() - couple other minor cleanups as requested in: https://lore.kernel.org/linux-riscv/20220709160206.cw5luo7kxdshoiua@xxxxxxxxxxxxxx/ Changes from v4: - dropped some accidentally added files Conor Dooley (4): dt-bindings: pwm: fix microchip corePWM's pwm-cells riscv: dts: fix the icicle's #pwm-cells pwm: add microchip soft ip corePWM driver MAINTAINERS: add pwm to PolarFire SoC entry .../bindings/pwm/microchip,corepwm.yaml | 4 +- MAINTAINERS | 1 + .../dts/microchip/mpfs-icicle-kit-fabric.dtsi | 2 +- drivers/pwm/Kconfig | 10 + drivers/pwm/Makefile | 1 + drivers/pwm/pwm-microchip-core.c | 397 ++++++++++++++++++ 6 files changed, 413 insertions(+), 2 deletions(-) create mode 100644 drivers/pwm/pwm-microchip-core.c -- 2.37.3
