This patch set is v2 of the catch up with latest Berlin improvements provided by Antoine - in particular SATA PHY support and AHCI generic for Berlin BG2. Marvell BSP code for BG2 suggests more differences between the two PHY revisions found on BG2 and BG2Q, but the only important one seems to be the PHY_BASE used in AHCI vendor-specific registers. I also confirmed that power_off does indeed power off the PHY on BG2, too (It wasn't very clear in BSP code). Anyway, I have tested this on BG2-based Sony NSZ-GS7 and attached SATA HDD is successfully detected and partitions are displayed. This patch set is now based on v3.18-rc1. As usual a branch based on v3.18-rc1 can be found at git://git.infradead.org/users/hesselba/linux-berlin.git devel/bg2-sata-v2 Compared to v1, there is only a minor change that removes an unrequired status = "disabled" property from BG2 SATA node. Patches 1-3 should go through Kishon's PHY tree, I pick up DT patches 4 and 5. Patch 1 prepares phy-berlin-sata to support different PHY_BASE addresses by moving the constant to driver private data. Patches 2 and 3 add a new compatible to driver and DT documentation that reflects the differences between BG2Q and BG2 SATA PHY. Patches 4 and 5 finally add DT nodes to both Berlin2 SoC dtsi and Sony NSZ-GS7 board DT file. SATA plug on NSZ-GS7 is unpopulated but can be very easily equipped with SATA receptable and some 0402 caps. I decided to enable SATA by default although not all users may populate it. Sebastian Hesselbarth (5): phy: berlin-sata: Move PHY_BASE into private data struct phy: berlin-sata: Add support for BG2 SATA PHY phy: berlin-sata: Document BG2 compatible ARM: berlin: Add AHCI and SATA PHY nodes to BG2 ARM: berlin: Enable SATA on Sony NSZ-GS7 .../devicetree/bindings/phy/berlin-sata-phy.txt | 4 +- arch/arm/boot/dts/berlin2-sony-nsz-gs7.dts | 7 ++++ arch/arm/boot/dts/berlin2.dtsi | 39 ++++++++++++++++++ drivers/phy/phy-berlin-sata.c | 48 +++++++++++++++------- 4 files changed, 83 insertions(+), 15 deletions(-) --- Cc: Kishon Vijay Abraham I <kishon@xxxxxx> Cc: "Antoine Ténart" <antoine.tenart@xxxxxxxxxxxxxxxxxx> Cc: devicetree@xxxxxxxxxxxxxxx Cc: linux-arm-kernel@xxxxxxxxxxxxxxxxxxx Cc: linux-kernel@xxxxxxxxxxxxxxx -- 2.1.1 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
