The ocelot-ext driver is another sub-device of the Ocelot / Felix driver
system, which currently supports the four internal copper phys.
Signed-off-by: Colin Foster <colin.foster@xxxxxxxxxxxxxxxx>
---
v3
* Remove "currently supported" verbage
The Seville and Felix 9959 all list their supported modes following
the sentence "The following PHY interface types are supported".
During V2, I had used "currently supported" to suggest more interface
modes are around the corner, though this had raised questions.
The suggestion was to drop the entire sentence. I did leave the
modified sentence there because it exactly matches the other two
supported products.
v2
* New patch
---
.../bindings/net/dsa/mscc,ocelot.yaml | 59 +++++++++++++++++++
1 file changed, 59 insertions(+)
diff --git a/Documentation/devicetree/bindings/net/dsa/mscc,ocelot.yaml b/Documentation/devicetree/bindings/net/dsa/mscc,ocelot.yaml
index 8d93ed9c172c..49450a04e589 100644
--- a/Documentation/devicetree/bindings/net/dsa/mscc,ocelot.yaml
+++ b/Documentation/devicetree/bindings/net/dsa/mscc,ocelot.yaml
@@ -54,9 +54,22 @@ description: |
- phy-mode = "1000base-x": on ports 0, 1, 2, 3
- phy-mode = "2500base-x": on ports 0, 1, 2, 3
+ VSC7412 (Ocelot-Ext):
+
+ The Ocelot family consists of four devices, the VSC7511, VSC7512, VSC7513,
+ and the VSC7514. The VSC7513 and VSC7514 both have an internal MIPS
+ processor that natively support Linux. Additionally, all four devices
+ support control over external interfaces, SPI and PCIe. The Ocelot-Ext
+ driver is for the external control portion.
+
+ The following PHY interface types are supported:
+
+ - phy-mode = "internal": on ports 0, 1, 2, 3
+
properties:
compatible:
enum:
+ - mscc,vsc7512-switch
- mscc,vsc9953-switch
- pci1957,eef0
@@ -258,3 +271,49 @@ examples:
};
};
};
+ # Ocelot-ext VSC7512
+ - |
+ spi {
+ soc@0 {
+ compatible = "mscc,vsc7512";
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ ethernet-switch@0 {
+ compatible = "mscc,vsc7512-switch";
+ reg = <0 0>;
+
+ ethernet-ports {
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ port@0 {
+ reg = <0>;
+ label = "cpu";
+ ethernet = <&mac_sw>;
+ phy-handle = <&phy0>;
+ phy-mode = "internal";
+ };
+
+ port@1 {
+ reg = <1>;
+ label = "swp1";
+ phy-mode = "internal";
+ phy-handle = <&phy1>;
+ };
+
+ port@2 {
+ reg = <2>;
+ phy-mode = "internal";
+ phy-handle = <&phy2>;
+ };
+
+ port@3 {
+ reg = <3>;
+ phy-mode = "internal";
+ phy-handle = <&phy3>;
+ };
+ };
+ };
+ };
+ };
--
2.25.1
