On Wed, Sep 14, 2022 at 08:58:43AM -0500, Shenwei Wang wrote: > i.MX8DXL is a device targeting the automotive and industrial market > segments. The chip is designed to achieve both high performance and > low power consumption. It has a dual (2x) Cortex-A35 processor. > > The series of patches is to add the imx8dxl soc and its evk board > support. > > changes in V8: > - change the flag of gpio phandle in reg_fec1_sel node to > GPIO_ACTIVE_LOW to match the hardware behavior. > > changes in V7: > - move the fec1 reset gpio into its phy node > > changes in V6: > - The V6 changes mainly respond to the comments from Shawn > - Separate the V5 patch into SoC and Board commits > - Remove the unnecessary properties of "max-frequency" > in usdhc2 node > - Remove the unnecessary properties of "clk_csr" in eqos node > - Fix several coding style problems > > changes in V5: > - change the "scu" node name to "system-controller" > - fix the typo in the comments for imx8dxl evk board > > changes in V4: > - move i2c/mmc/serial aliases from soc to board > - correct the node names to follow the generic names recommendation > - remove some unused nodes in the evk board dts > > changes in V3: > - re-order the commit sequence according to Krzysztof's feedback > - correct the syntax and styple problems pointed by Krzysztof > (Thank you for the detailed review, Krzysztof!) > - remove the unused nodes in imx8dxl-evk.dts > - dt_binding_check passed > > Changes in V2: > - removed the edma2 device node because the edma v3 driver hasn't been > upstreamed yet. > - removed the imx8dxl_cm4 alias to fix the compile error. > - removed the extra blank lines at EOF. > - dt_binding_check passed. > > Shenwei Wang (5): > dt-bindings: firmware: add missing resource IDs for imx8dxl > dt-bindings: arm: imx: update fsl.yaml for imx8dxl > arm64: dts: imx8: add a node label to ddr-pmu > arm64: dts: freescale: add i.MX8DXL SoC support > arm64: dts: freescale: add support for i.MX8DXL EVK board Applied all, thanks!
