Hi Arnd,
On 2022/09/12 17:36, Arnd Bergmann wrote:
On Mon, Sep 12, 2022, at 9:15 AM, Kunihiko Hayashi wrote:
Add ahci controller and glue layer nodes including reset and phy.
This supports for PXs2 and the boards without PXs2 vodka board that
doesn't implement any SATA connectors.
Signed-off-by: Kunihiko Hayashi <hayashi.kunihiko@xxxxxxxxxxxxx>
+ ahci: ahci@65600000 {
+ compatible = "socionext,uniphier-pxs2-ahci",
+ "generic-ahci";
+ status = "disabled";
+ reg = <0x65600000 0x10000>;
+ interrupts = <GIC_SPI 142 IRQ_TYPE_LEVEL_HIGH>;
+ clocks = <&sys_clk 28>;
+ resets = <&sys_rst 28>, <&ahci_rst 0>;
+ ports-implemented = <1>;
+ phys = <&ahci_phy>;
+ };
+
+ ahci-glue@65700000 {
+ compatible = "socionext,uniphier-pxs2-ahci-glue",
+ "simple-mfd";
Here as well, the "ahci-glue" name seems rather unusual for a node
name. What does it actually do, and why is this not just part of
the sata node?
According to ata/sata-common.yaml, "ahci@65600000" node for generic SATA
host controller is better expressed as "sata@65600000". I'll fix it.
However, "ahci-glue@65700000" is the integration of SATA related functions
(reset and phy). Maybe "sata-controller" seems to be the best, but
I couldn't find this usage.
+ #address-cells = <1>;
+ #size-cells = <1>;
+ ranges = <0 0x65700000 0x100>;
+
+ ahci_rst: reset@0 {
+ compatible =
"socionext,uniphier-pxs2-ahci-reset";
I think the node name here should be "reset-controller@0".
Yes, I'll fix it.
+
+ ahci_phy: phy@10 {
+ compatible =
"socionext,uniphier-pxs2-ahci-phy";
and "sata-phy@10" here.
I'll fix it too.
Thank you,
---
Best Regards
Kunihiko Hayashi