On śro, 2014-10-08 at 15:44 +0200, Javier Martinez Canillas wrote:
> Regulators can run on different operating modes (opmodes). This allows
> systems to choose the most efficient opmode for each regulator. The
> regulator core defines a set of generic modes so each system can define
> the opmode in these generic terms and drivers are responsible to map the
> generic modes to the ones supported by each hardware according to their
> data-sheet.
>
> Signed-off-by: Javier Martinez Canillas <javier.martinez@xxxxxxxxxxxxxxx>
> ---
> Documentation/devicetree/bindings/regulator/regulator.txt | 8 ++++++++
> 1 file changed, 8 insertions(+)
>
> diff --git a/Documentation/devicetree/bindings/regulator/regulator.txt b/Documentation/devicetree/bindings/regulator/regulator.txt
> index ccba90b..a9d6767 100644
> --- a/Documentation/devicetree/bindings/regulator/regulator.txt
> +++ b/Documentation/devicetree/bindings/regulator/regulator.txt
> @@ -23,6 +23,14 @@ Optional properties:
> state among following defined suspend states:
> <3>: PM_SUSPEND_MEM - Setup regulator according to regulator-state-mem
> <4>: PM_SUSPEND_MAX - Setup regulator according to regulator-state-disk
> +- regulator-initial-mode: initial regulator operating mode. One of following:
> + <1>: REGULATOR_MODE_FAST - Regulator can handle fast changes.
> + <2>: REGULATOR_MODE_NORMAL - Normal regulator power supply mode.
> + <4>: REGULATOR_MODE_IDLE - Regulator runs in a more efficient mode.
> + <8>: REGULATOR_MODE_STANDBY - Regulator runs in the most efficient mode.
> + modes are defined in the dt-bindings/regulator/regulator.h header and can be
> + used in device tree sources files. If no mode is defined, then the OS will not
> + manage the operating mode and the HW default values will be used instead.
> - regulator-state-mem sub-root node for Suspend-to-RAM mode
> : suspend to memory, the device goes to sleep, but all data stored in memory,
> only some external interrupt can wake the device.
I agree with the need and the idea of generic bindings for operating
modes for regulators. At least for Exynos-based boards the PMICs have
quite similar opmodes.
However the regulator mode from consumer.h (and in above doc) does not
match well with these opmodes. Example is yours patch 4/5:
- idle ("more efficient mode") maps to "low power mode in suspend",
- standby ("the most efficient mode") maps to "OFF in suspend".
Actually we are not enable "efficient modes" but we configure how the
regulator will behave when AP says - I'm suspending.
Another issue: is "initial_state" not doing all this already?
Best regards,
Krzysztof
--
To unsubscribe from this list: send the line "unsubscribe devicetree" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
