On Fri, Aug 19, 2022 at 3:01 PM Bjorn Andersson <bjorn.andersson@xxxxxxxxxx> wrote: > > > You can't physically connect 1, 2 or 4 lanes of DP from a DP chip to > your usb-c-connector at the same time as you physically connect 0, 2 or > 4 lanes of USB from a USB PHY. I apologize in case I'm misunderstanding, but why is that not possible? anx7625 allows that configuration (2 lane DP + 2 lane USB going to a single USB-C-connector) Since the discussion is to support various conceivable hardware configurations That same anx7625 can support 1 1-lane DP (or 2 1-lane DPs), and 1 2-lane Type-C output. The cross-point switch allows for that level of configuration. > > So, how about 4 endpoints (1 for each SS lane) in the usb-c-connector port@1? > > That should support every conceivable configuration and bridge/PHY hardware. > > and also allows a way to specify any lane remapping (similar to what > > "data lanes" does) > > if that is required. > > Wouldn't that prevent you from handling orientation switching, given > that the graph is static? It depends. If the end-points from the usb-c-connector go to the same switch, then it should allow orientation switching (anx7625 allows this). The port driver would just tell the orientation switch(es) attached to it that we are in NORMAL or REVERSE orientation. The graph is static, since the hardware line routing between components doesn't change (e.g SSTX1 from the Type-C port is always routed to Pin X1,X2 on the switch hardware), but that is what the switch is for. Note that in this case, the expectation is that the switch driver only registers 1 switch (it can figure out that all 4 endpoints go to the same Type-C port). The limitation to orientation switching would depend on how the hardware is routed.
