Add support for QSGMII mode to am65-cpsw driver. Change log: v3 -> v4: 1. Update bindings to disallow ports based on compatible, instead of adding a new if/then statement for the new compatible. 2. Add Else-If condition for RMII mode in the set of supported interfaces. Support for RMII mode is already present in the driver and I had missed out adding a condition for RMII mode in the previous patches. v2 -> v3: 1. In ti,k3-am654-cpsw-nuss.yaml, restrict if/then statement to port nodes. v1 -> v2: 1. Add new compatible for CPSW5G in ti,k3-am654-cpsw-nuss.yaml and extend properties for new compatible. 2. Add extra_modes member to struct am65_cpsw_pdata to be used for QSGMII mode by new compatible. 3. Add check for phylink supported modes to ensure that only one phy mode is advertised as supported. 4. Check if extra_modes supports QSGMII mode in am65_cpsw_nuss_mac_config() for register write. 5. Add check for assigning port->sgmii_base only when extra_modes is valid. v3: https://lore.kernel.org/r/20220606110443.30362-1-s-vadapalli@xxxxxx/ v2: https://lore.kernel.org/r/20220602114558.6204-1-s-vadapalli@xxxxxx/ v1: https://lore.kernel.org/r/20220531113058.23708-1-s-vadapalli@xxxxxx/ Siddharth Vadapalli (3): dt-bindings: net: ti: k3-am654-cpsw-nuss: Update bindings for J7200 CPSW5G net: ethernet: ti: am65-cpsw: Add support for J7200 CPSW5G net: ethernet: ti: am65-cpsw: Move phy_set_mode_ext() to correct location .../bindings/net/ti,k3-am654-cpsw-nuss.yaml | 17 ++++++- drivers/net/ethernet/ti/am65-cpsw-nuss.c | 44 ++++++++++++++++--- drivers/net/ethernet/ti/am65-cpsw-nuss.h | 2 + 3 files changed, 54 insertions(+), 9 deletions(-) -- 2.25.1
