Re: [PATCH] arm64: dts: qcom: pm6350: add temp sensor and thermal zone config

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 12/08/2022 14:44, Luca Weiss wrote:
> Add temp-alarm device tree node and a default configuration for the
> corresponding thermal zone for this PMIC. Temperatures are based on
> downstream values.
> 
> Signed-off-by: Luca Weiss <luca.weiss@xxxxxxxxxxxxx>
> ---
> With this config I'm getting this in dmesg, not sure if it's a warning
> that should be solved or just an informative warning.
> 
> [    0.268256] spmi-temp-alarm c440000.spmi:pmic@0:temp-alarm@2400: No ADC is configured and critical temperature is above the maximum stage 2 threshold of 140 C! Configuring stage 2 shutdown at 140 C.
> 
> As far as I can tell, based on downstream dts this PMIC doesn't have an
> ADC.

You configure 145 and driver believes 140 is the limit, so it seems
warning should be addressed.

>From where did you get 145 degrees as limit? Downstream DTS?

Best regards,
Krzysztof



[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux