The OLDI TX(es) require a serial clock which is 7 times the pixel clock
of the display panel. When the OLDI is enabled in DSS, the pixel clock
input of the corresponding videoport gets a divided-by 7 value of the
requested clock.
For the am625-dss, the requested clock needs to be 7 times the value.
Update the clock frequency by requesting 7 times the value.
Signed-off-by: Aradhya Bhatia <a-bhatia1@xxxxxx>
---
drivers/gpu/drm/tidss/tidss_dispc.c | 10 ++++++++++
1 file changed, 10 insertions(+)
diff --git a/drivers/gpu/drm/tidss/tidss_dispc.c b/drivers/gpu/drm/tidss/tidss_dispc.c
index c4a5f808648f..0b9689453ee8 100644
--- a/drivers/gpu/drm/tidss/tidss_dispc.c
+++ b/drivers/gpu/drm/tidss/tidss_dispc.c
@@ -1326,6 +1326,16 @@ int dispc_vp_set_clk_rate(struct dispc_device *dispc, u32 hw_videoport,
int r;
unsigned long new_rate;
+ /*
+ * For AM625 OLDI video ports, the requested pixel clock needs to take into account the
+ * serial clock required for the serialization of DPI signals into LVDS signals. The
+ * incoming pixel clock on the OLDI video port gets divided by 7 whenever OLDI enable bit
+ * gets set.
+ */
+ if (dispc->feat->vp_bus_type[hw_videoport] == DISPC_VP_OLDI &&
+ dispc->feat->subrev == DISPC_AM625)
+ rate *= 7;
+
r = clk_set_rate(dispc->vp_clk[hw_videoport], rate);
if (r) {
dev_err(dispc->dev, "vp%d: failed to set clk rate to %lu\n",
--
2.37.0
