From: Pali Rohár <pali@xxxxxxxxxx>
Add definitions for PCIe legacy INTx interrupts.
This is required for example in a scenario where a driver requests only
one of the legacy interrupts (INTA). Without this, the driver would be
notified on events on all 4 (INTA, INTB, INTC, INTD), even if it
requested only one of them.
Signed-off-by: Pali Rohár <pali@xxxxxxxxxx>
Signed-off-by: Marek Behún <kabel@xxxxxxxxxx>
---
arch/arm/boot/dts/armada-xp-98dx3236.dtsi | 14 ++++++++++++--
1 file changed, 12 insertions(+), 2 deletions(-)
diff --git a/arch/arm/boot/dts/armada-xp-98dx3236.dtsi b/arch/arm/boot/dts/armada-xp-98dx3236.dtsi
index 38a052a0312d..b21ffb819b1d 100644
--- a/arch/arm/boot/dts/armada-xp-98dx3236.dtsi
+++ b/arch/arm/boot/dts/armada-xp-98dx3236.dtsi
@@ -76,16 +76,26 @@ pcie1: pcie@1,0 {
reg = <0x0800 0 0 0 0>;
#address-cells = <3>;
#size-cells = <2>;
+ interrupt-names = "intx";
+ interrupts-extended = <&mpic 58>;
#interrupt-cells = <1>;
ranges = <0x82000000 0 0 0x82000000 0x1 0 1 0
0x81000000 0 0 0x81000000 0x1 0 1 0>;
bus-range = <0x00 0xff>;
- interrupt-map-mask = <0 0 0 0>;
- interrupt-map = <0 0 0 0 &mpic 58>;
+ interrupt-map-mask = <0 0 0 7>;
+ interrupt-map = <0 0 0 1 &pcie1_intc 0>,
+ <0 0 0 2 &pcie1_intc 1>,
+ <0 0 0 3 &pcie1_intc 2>,
+ <0 0 0 4 &pcie1_intc 3>;
marvell,pcie-port = <0>;
marvell,pcie-lane = <0>;
clocks = <&gateclk 5>;
status = "disabled";
+
+ pcie1_intc: interrupt-controller {
+ interrupt-controller;
+ #interrupt-cells = <1>;
+ };
};
};
--
2.35.1
