Hey Uwe, all, Added some extra patches so I have a cover letter this time. You pointed out that I was overriding npwmcells in the driver and I realised that the dt & binding were not correct so I have added two simple patches to deal with that. The dts patch I will take in my tree once the binding is applied. For the maintainers entry, I mentioned before that I have several changes in-flight for it. We are late(ish) in the cycle so I doubt you'll be applying this for v5.20, but in the off chance you do - I would be happy to send it (with your Ack) alongside an i2c addition that is "deferred". I rebased it today on top of an additional change so it may not apply for you. In your review of v3, you had a lot of comments about the period and duty cycle calculations, so I have had another run at them. I converted the period calculation to "search" from the bottom up for the suitable prescale value. The duty cycle calculation has been fixed - the problem was exactly what I suspected in my replies to your review. I had to block the use of a 0xFF period_steps register value (which I think should be covered by the updated comment and limitation #2). Beyond that, I have rebased on -next and converted to the devm_ stuff in probe that was recently added & dropped remove() - as requested. I added locking to protect the period racing, changed the #defines and switched to returning -EINVAL when the period is locked to a value greater than that requested. Thanks, Conor. Changes from v5: - switched to a mutex b/c we must sleep with the lock taken - simplified the locking in apply() and added locking to get_state() - reworked apply() as requested - removed the loop in the period calculation (thanks Uwe!) - add a copy of the enable registers in the driver to save on reads. - remove the second (useless) write to sync_update - added some missing rounding in get_state() - couple other minor cleanups as requested in: https://lore.kernel.org/linux-riscv/20220709160206.cw5luo7kxdshoiua@xxxxxxxxxxxxxx/ Changes from v4: - dropped some accidentally added files Conor Dooley (4): dt-bindings: pwm: fix microchip corePWM's pwm-cells riscv: dts: fix the icicle's #pwm-cells pwm: add microchip soft ip corePWM driver MAINTAINERS: add pwm to PolarFire SoC entry .../bindings/pwm/microchip,corepwm.yaml | 4 +- MAINTAINERS | 1 + .../dts/microchip/mpfs-icicle-kit-fabric.dtsi | 2 +- drivers/pwm/Kconfig | 10 + drivers/pwm/Makefile | 1 + drivers/pwm/pwm-microchip-core.c | 370 ++++++++++++++++++ 6 files changed, 386 insertions(+), 2 deletions(-) create mode 100644 drivers/pwm/pwm-microchip-core.c base-commit: 734339e5c1c46e3af041b4c288c213e045e34354 -- 2.36.1
