On 06/07/2022 13:55, Krishna Chaitanya Chundru wrote: > > On 7/4/2022 1:54 PM, Krzysztof Kozlowski wrote: >> On 01/07/2022 18:11, Krishna chaitanya chundru wrote: >>> Adding aggre0 and aggre1 clock entries to PCIe node. >>> >>> Signed-off-by: Krishna chaitanya chundru <quic_krichai@xxxxxxxxxxx> >>> --- >>> Documentation/devicetree/bindings/pci/qcom,pcie.yaml | 6 ++++-- >>> 1 file changed, 4 insertions(+), 2 deletions(-) >>> >>> diff --git a/Documentation/devicetree/bindings/pci/qcom,pcie.yaml b/Documentation/devicetree/bindings/pci/qcom,pcie.yaml >>> index 0b69b12..8f29bdd 100644 >>> --- a/Documentation/devicetree/bindings/pci/qcom,pcie.yaml >>> +++ b/Documentation/devicetree/bindings/pci/qcom,pcie.yaml >>> @@ -423,8 +423,8 @@ allOf: >>> then: >>> properties: >>> clocks: >>> - minItems: 11 >>> - maxItems: 11 >>> + minItems: 13 >>> + maxItems: 13 >>> clock-names: >>> items: >>> - const: pipe # PIPE clock >>> @@ -437,6 +437,8 @@ allOf: >>> - const: bus_slave # Slave AXI clock >>> - const: slave_q2a # Slave Q2A clock >>> - const: tbu # PCIe TBU clock >>> + - const: aggre0 # Aggre NoC PCIe CENTER SF AXI clock >>> + - const: aggre1 # Aggre NoC PCIe1 AXI clock >> You ignored my comments from v1 - please don't. This is not accepted. >> >> Also, please do not send new versions of patchset as reply to some other >> threads. It's extremely confusing to find it under something else. >> >> Best regards, >> Krzysztof > Hi > > Krzysztof, > > Sorry for confusion created which replying this patch. > > The only comment I got from v1 from you is to run make dtbs_check. > > I ran that command I found the errors and fixed them and I ran the make dtbs_check again > before on v2 and made sure there are no errors. > > Can you please tell me is there any steps I missed. The comment was: "This won't work. You need to update other entry." and then a conditional: "If you test it with `make dtbs_check` you will see the errors." So let's run it together: /home/krzk/dev/linux/linux/out/arch/arm64/boot/dts/qcom/sc7280-idp.dtb: pci@1c08000: clocks: [[42, 55], [42, 56], [41, 0], [39, 0], [42, 50], [42, 52], [42, 53], [42, 57], [42, 58], [42, 177], [42, 178], [42, 8], [42, 21]] is too long From schema: /home/krzk/dev/linux/linux/Documentation/devicetree/bindings/pci/qcom,pcie.yaml /home/krzk/dev/linux/linux/out/arch/arm64/boot/dts/qcom/sc7280-idp.dtb: pci@1c08000: clock-names: ['pipe', 'pipe_mux', 'phy_pipe', 'ref', 'aux', 'cfg', 'bus_master', 'bus_slave', 'slave_q2a', 'tbu', 'aggre0', 'aggre1', 'ddrss_sf_tbu'] is too long clocks and clock-names can be maximum 12 items, as defined by schema in "properties:" section. You cannot extend it in one place to 13 but leave 12 in other, because both constraints are applicable. If you test it, you will see the errors. Best regards, Krzysztof
