Hi Peng,
On 3.07.22 12:11, Peng Fan (OSS) wrote:
From: Peng Fan <peng.fan@xxxxxxx>
Add i.MX8MP NoC node to make the interconnect i.MX8MP driver could work.
Currently dynamic frequency scaling of the i.MX8MP NoC has not been
supported, only NoC initial settings are configured by interconnect
driver.
Signed-off-by: Peng Fan <peng.fan@xxxxxxx>
---
arch/arm64/boot/dts/freescale/imx8mp.dtsi | 22 ++++++++++++++++++++++
1 file changed, 22 insertions(+)
diff --git a/arch/arm64/boot/dts/freescale/imx8mp.dtsi b/arch/arm64/boot/dts/freescale/imx8mp.dtsi
index eb2d516278eb..13a2ee77d3c6 100644
--- a/arch/arm64/boot/dts/freescale/imx8mp.dtsi
+++ b/arch/arm64/boot/dts/freescale/imx8mp.dtsi
@@ -4,6 +4,7 @@
*/
#include <dt-bindings/clock/imx8mp-clock.h>
+#include <dt-bindings/interconnect/fsl,imx8mp.h>
It's also possible to drop this line for now and add it in the next patches when we add the
interconnect consumers. This will allow merging this DT patch independently. But it's up to Shawn.
#include <dt-bindings/power/imx8mp-power.h>
#include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/input/input.h>
@@ -1019,6 +1020,27 @@ eqos: ethernet@30bf0000 {
};
};
+ noc: interconnect@32700000 {
+ compatible = "fsl,imx8mp-noc", "fsl,imx8m-noc", "syscon";
I got the impression that we are dropping the syscon, or not?
+ reg = <0x32700000 0x100000>;
+ clocks = <&clk IMX8MP_CLK_NOC>;
+ #interconnect-cells = <1>;
+
+ operating-points-v2 = <&noc_opp_table>;
+
+ noc_opp_table: opp-table {
+ compatible = "operating-points-v2";
+
+ opp-200M {
+ opp-hz = /bits/ 64 <200000000>;
+ };
+
+ opp-1000M {
+ opp-hz = /bits/ 64 <1000000000>;
+ };
+ };
+ };
+
aips4: bus@32c00000 {
compatible = "fsl,aips-bus", "simple-bus";
reg = <0x32c00000 0x400000>;
Patches 1-9 look good and I am planning to merge them.
Thanks,
Georgi
