On 28/06/2022 16:22, Michael Walle wrote: >>> I can't follow you here. Please note, that you need the actual >>> physical port number. It's not a made up number, but corresponds >>> to a physical port on that ethernet switch. So you can't just skip >>> the disabled ones. port@2 must have port number 2. >> >> The number "2" you get from the reg property, so where is exactly the >> problem? > > That you need to get the total number of ports of the hardware (which > is also used for things beyond validation, eg. during switch init > all ports will are disabled). And right now, that is done by counting > all the nodes - which is bad, I guess we agree here. It's bad also from another reason - the DT node was explicitly disabled, but you perform some operation on actual hardware representing this node. I would assume that a disabled DT node means it is not operational, e.g. hardware not present or missing clocks, so you should not treat it as another meaning - power down/unused. > But it works, > as long as no ports are disabled and all ports are described in the > device tree. But I have device trees where some are disabled. I am not sure if I follow this. You have devices which 1. have unused ports, but all DT nodes are available/okay, 2. have unused ports, which are in DT status=disabled? Doesn't case 2 break the bindings? If so, we don't care about such out-of-tree users. We cannot support all of possible weird combinations in out-of-tree DTS files... > > I assume, you cannot read the hardware itself to get the number of > physical ports; and we have the compatible "microchip,lan966x-switch", > which is the generic one, so it could be the LAN9668 (with 8 ports) > or the LAN9662 (with 2 ports). I'll keep that argument for future when I see again patches adding such wildcard compatible. :) I had to discuss with some folks... Although the compatible difference does not have to be important here, because one could say the 9662 and 9668 programming model is exaclty the same and they differ by number of ports. This number of ports can be a dedicated property or counted from the children (if they were all available). > We somehow have to retain backwards > compatibility. Thus my idea was to at least make the handling slightly > better and count *any* child nodes. So it doesn't fall apart with > disabled > nodes. Then introduce proper compatible strings > "microchip,lan9668-switch" > and use that to hardcode the num_phys_ports to 8. But there will be > device trees with microchip,lan966x-switch out there, which we do want > to support. > > I see the following options: > (1) just don't care and get rid of the "microchip,lan966x-switch" > compatible > (2) quick fix for the older kernels by counting all the nodes and > proper fix for the newer kernels with dedicated compatibles > (3) no fix for older kernels, introduce new compatibles for new > kernels I propose this one. I would not care about out-of-tree DTSes which decided to disable random stuff and expect things working. :) > (4) keep generic compatible if the hardware can be read out to get > the number of ports. > > I think (1) isn't the way to go. (2) was my try until I noticed > that odd fwnode behavior. But judging by this thread, I don't think > thats possible. I don't know if (4) is possible at all. If not we'd > be left with (3). Best regards, Krzysztof
