There are a few Ocelot chips that contain pinctrl logic, but can be controlled externally. Specifically the VSC7511, 7512, 7513 and 7514. In the externally controlled configurations these registers are not memory-mapped. Add support for these non-memory-mapped configurations. Signed-off-by: Colin Foster <colin.foster@xxxxxxxxxxxxxxxx> --- drivers/pinctrl/pinctrl-ocelot.c | 11 ++++------- 1 file changed, 4 insertions(+), 7 deletions(-) diff --git a/drivers/pinctrl/pinctrl-ocelot.c b/drivers/pinctrl/pinctrl-ocelot.c index 5554c3014448..655bada7cc4b 100644 --- a/drivers/pinctrl/pinctrl-ocelot.c +++ b/drivers/pinctrl/pinctrl-ocelot.c @@ -10,6 +10,7 @@ #include <linux/gpio/driver.h> #include <linux/interrupt.h> #include <linux/io.h> +#include <linux/mfd/ocelot.h> #include <linux/of_device.h> #include <linux/of_irq.h> #include <linux/of_platform.h> @@ -1918,7 +1919,6 @@ static int ocelot_pinctrl_probe(struct platform_device *pdev) struct ocelot_pinctrl *info; struct reset_control *reset; struct regmap *pincfg; - void __iomem *base; int ret; struct regmap_config regmap_config = { .reg_bits = 32, @@ -1938,16 +1938,12 @@ static int ocelot_pinctrl_probe(struct platform_device *pdev) "Failed to get reset\n"); reset_control_reset(reset); - base = devm_ioremap_resource(dev, - platform_get_resource(pdev, IORESOURCE_MEM, 0)); - if (IS_ERR(base)) - return PTR_ERR(base); - info->stride = 1 + (info->desc->npins - 1) / 32; regmap_config.max_register = OCELOT_GPIO_SD_MAP * info->stride + 15 * 4; - info->map = devm_regmap_init_mmio(dev, base, ®map_config); + info->map = ocelot_platform_init_regmap_from_resource(pdev, 0, + ®map_config); if (IS_ERR(info->map)) { dev_err(dev, "Failed to create regmap\n"); return PTR_ERR(info->map); @@ -1989,3 +1985,4 @@ builtin_platform_driver(ocelot_pinctrl_driver); MODULE_DESCRIPTION("Ocelot Chip Pinctrl Driver"); MODULE_LICENSE("Dual MIT/GPL"); +MODULE_IMPORT_NS(MFD_OCELOT); -- 2.25.1