1. The dt-binding expects that drive-strength arguments be passed
in mA, but the driver was expecting raw values. And that this
commit changes the driver so that it is aligned with the binding.
2. This commit provides generic driving setup, which support
2/4/6/8/10/12/14/16mA driving, original driver just set raw data
setup setting when use drive-strength property.
Signed-off-by: Guodong Liu <guodong.liu@xxxxxxxxxxxx>
---
drivers/pinctrl/mediatek/pinctrl-mt8192.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/pinctrl/mediatek/pinctrl-mt8192.c b/drivers/pinctrl/mediatek/pinctrl-mt8192.c
index acccde9262ba..2421a12fc573 100644
--- a/drivers/pinctrl/mediatek/pinctrl-mt8192.c
+++ b/drivers/pinctrl/mediatek/pinctrl-mt8192.c
@@ -1372,8 +1372,8 @@ static const struct mtk_pin_soc mt8192_data = {
.gpio_m = 0,
.bias_set_combo = mtk_pinconf_bias_set_combo,
.bias_get_combo = mtk_pinconf_bias_get_combo,
- .drive_set = mtk_pinconf_drive_set_raw,
- .drive_get = mtk_pinconf_drive_get_raw,
+ .drive_set = mtk_pinconf_drive_set_rev1,
+ .drive_get = mtk_pinconf_drive_get_rev1,
.adv_pull_get = mtk_pinconf_adv_pull_get,
.adv_pull_set = mtk_pinconf_adv_pull_set,
.adv_drive_get = mtk_pinconf_adv_drive_get,
--
2.25.5
