From: Sherry Sun <sherry.sun@xxxxxxx> According to the IOMUXC_SW_PAD_CTL_PAD_UART2_RXD/TXD register define in imx8mp RM, bit0 and bit3 are reserved, and the uart2 rx/tx pin should enable the pull up, so need to set bit8 to 1. The original pinctl value 0x49 is incorrect and needs to be changed to 0x140, same as uart1 and uart3. Fixes: 9e847693c6f3 ("arm64: dts: freescale: Add i.MX8MP EVK board support") Reviewed-by: Haibo Chen <haibo.chen@xxxxxxx> Signed-off-by: Sherry Sun <sherry.sun@xxxxxxx> Signed-off-by: Peng Fan <peng.fan@xxxxxxx> --- arch/arm64/boot/dts/freescale/imx8mp-evk.dts | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/arch/arm64/boot/dts/freescale/imx8mp-evk.dts b/arch/arm64/boot/dts/freescale/imx8mp-evk.dts index 703b03a7b90b..b2f6c1dc8104 100644 --- a/arch/arm64/boot/dts/freescale/imx8mp-evk.dts +++ b/arch/arm64/boot/dts/freescale/imx8mp-evk.dts @@ -522,8 +522,8 @@ MX8MP_IOMUXC_SD2_RESET_B__GPIO2_IO19 0x40 pinctrl_uart2: uart2grp { fsl,pins = < - MX8MP_IOMUXC_UART2_RXD__UART2_DCE_RX 0x49 - MX8MP_IOMUXC_UART2_TXD__UART2_DCE_TX 0x49 + MX8MP_IOMUXC_UART2_RXD__UART2_DCE_RX 0x140 + MX8MP_IOMUXC_UART2_TXD__UART2_DCE_TX 0x140 >; }; -- 2.25.1