The USBH composed of EHCI and OHCI controllers needs the PHY clock to be
initialized first, before enabling (gating) them. The reverse is also
required when going to suspend.
So, add USBPHY clock as 1st entry in both controllers, so the USBPHY PLL
gets enabled 1st upon controller init. Upon suspend/resume, this also makes
the clock to be disabled/re-enabled in the correct order.
This fixes some IRQ storm conditions seen when going to low-power, due to
PHY PLL being disabled before all clocks are cleanly gated.
Fixes: 949a0c0dec85 ("ARM: dts: stm32: add USB Host (USBH) support to stm32mp157c")
Fixes: db7be2cb87ae ("ARM: dts: stm32: use usbphyc ck_usbo_48m as USBH OHCI clock on stm32mp151")
Signed-off-by: Fabrice Gasnier <fabrice.gasnier@xxxxxxxxxxx>
---
arch/arm/boot/dts/stm32mp151.dtsi | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/arch/arm/boot/dts/stm32mp151.dtsi b/arch/arm/boot/dts/stm32mp151.dtsi
index edc0a1641c7b..9e2226430802 100644
--- a/arch/arm/boot/dts/stm32mp151.dtsi
+++ b/arch/arm/boot/dts/stm32mp151.dtsi
@@ -1473,7 +1473,7 @@ stmmac_axi_config_0: stmmac-axi-config {
usbh_ohci: usb@5800c000 {
compatible = "generic-ohci";
reg = <0x5800c000 0x1000>;
- clocks = <&rcc USBH>, <&usbphyc>;
+ clocks = <&usbphyc>, <&rcc USBH>;
resets = <&rcc USBH_R>;
interrupts = <GIC_SPI 74 IRQ_TYPE_LEVEL_HIGH>;
status = "disabled";
@@ -1482,7 +1482,7 @@ usbh_ohci: usb@5800c000 {
usbh_ehci: usb@5800d000 {
compatible = "generic-ehci";
reg = <0x5800d000 0x1000>;
- clocks = <&rcc USBH>;
+ clocks = <&usbphyc>, <&rcc USBH>;
resets = <&rcc USBH_R>;
interrupts = <GIC_SPI 75 IRQ_TYPE_LEVEL_HIGH>;
companion = <&usbh_ohci>;
--
2.25.1
