From: Vijaya Krishna Nivarthi <quic_vnivarth@xxxxxxxxxxx> [ Upstream commit 497b272759986af1aa5a25b5e903d082c67bd8f6 ] WLAN rail was leaking power during RBSC/sleep even after turning BT off. Change active and sleep pinctrl configurations to handle same. Signed-off-by: Vijaya Krishna Nivarthi <quic_vnivarth@xxxxxxxxxxx> Reviewed-by: Douglas Anderson <dianders@xxxxxxxxxxxx> Signed-off-by: Bjorn Andersson <bjorn.andersson@xxxxxxxxxx> Link: https://lore.kernel.org/r/1650556567-4995-2-git-send-email-quic_vnivarth@xxxxxxxxxxx Signed-off-by: Sasha Levin <sashal@xxxxxxxxxx> --- arch/arm64/boot/dts/qcom/sc7280-idp.dtsi | 18 ++++++++++++------ 1 file changed, 12 insertions(+), 6 deletions(-) diff --git a/arch/arm64/boot/dts/qcom/sc7280-idp.dtsi b/arch/arm64/boot/dts/qcom/sc7280-idp.dtsi index d623d71d8bd4..dd6dac0e1784 100644 --- a/arch/arm64/boot/dts/qcom/sc7280-idp.dtsi +++ b/arch/arm64/boot/dts/qcom/sc7280-idp.dtsi @@ -462,10 +462,13 @@ &qup_uart5_rx { &qup_uart7_cts { /* - * Configure a pull-down on CTS to match the pull of - * the Bluetooth module. + * Configure a bias-bus-hold on CTS to lower power + * usage when Bluetooth is turned off. Bus hold will + * maintain a low power state regardless of whether + * the Bluetooth module drives the pin in either + * direction or leaves the pin fully unpowered. */ - bias-pull-down; + bias-bus-hold; }; &qup_uart7_rts { @@ -516,10 +519,13 @@ qup_uart7_sleep_cts: qup-uart7-sleep-cts { pins = "gpio28"; function = "gpio"; /* - * Configure a pull-down on CTS to match the pull of - * the Bluetooth module. + * Configure a bias-bus-hold on CTS to lower power + * usage when Bluetooth is turned off. Bus hold will + * maintain a low power state regardless of whether + * the Bluetooth module drives the pin in either + * direction or leaves the pin fully unpowered. */ - bias-pull-down; + bias-bus-hold; }; qup_uart7_sleep_rts: qup-uart7-sleep-rts { -- 2.35.1
