On Tue, 31 May 2022 15:21:07 +0530, Puranjay Mohan wrote: > Add a YAML binding document for the ICSSG Programmable real time unit > based Ethernet driver. This driver uses the PRU and PRUSS consumer APIs > to interface the PRUs and load/run the firmware for supporting ethernet > functionality. > > Signed-off-by: Puranjay Mohan <p-mohan@xxxxxx> > --- > v1: https://lore.kernel.org/all/20220506052433.28087-2-p-mohan@xxxxxx/ > v1 -> v2: > * Addressed Rob's Comments > * It includes indentation, formatting, and other minor changes. > --- > .../bindings/net/ti,icssg-prueth.yaml | 181 ++++++++++++++++++ > 1 file changed, 181 insertions(+) > create mode 100644 Documentation/devicetree/bindings/net/ti,icssg-prueth.yaml > My bot found errors running 'make DT_CHECKER_FLAGS=-m dt_binding_check' on your patch (DT_CHECKER_FLAGS is new in v5.13): yamllint warnings/errors: dtschema/dtc warnings/errors: ./Documentation/devicetree/bindings/net/ti,icssg-prueth.yaml: Unable to find schema file matching $id: http://devicetree.org/schemas/remoteproc/ti,pru-consumer.yaml /builds/robherring/linux-dt-review/Documentation/devicetree/bindings/net/ti,icssg-prueth.example.dtb: pruss2_eth: False schema does not allow {'compatible': ['ti,am654-icssg-prueth'], 'pinctrl-names': ['default'], 'pinctrl-0': [[4294967295]], 'sram': [[4294967295]], 'ti,prus': [[4294967295, 4294967295, 4294967295, 4294967295, 4294967295, 4294967295]], 'firmware-name': ['ti-pruss/am65x-pru0-prueth-fw.elf', 'ti-pruss/am65x-rtu0-prueth-fw.elf', 'ti-pruss/am65x-txpru0-prueth-fw.elf', 'ti-pruss/am65x-pru1-prueth-fw.elf', 'ti-pruss/am65x-rtu1-prueth-fw.elf', 'ti-pruss/am65x-txpru1-prueth-fw.elf'], 'ti,pruss-gp-mux-sel': [[2, 2, 2, 2, 2, 2]], 'ti,mii-g-rt': [[4294967295]], 'dmas': [[4294967295, 49920], [4294967295, 49921], [4294967295, 49922], [4294967295, 49923], [4294967295, 49924], [4294967295, 49925], [4294967295, 49926], [4294967295, 49927], [4294967295, 17152], [4294967295, 17153]], 'dma-names': ['tx0-0', 'tx0-1', 'tx0-2', 'tx0-3', 'tx1-0', 'tx1-1', 'tx1-2', 'tx1-3', 'rx0', 'rx1'], 'i nterrupts': [[24, 0, 2], [25, 1, 3]], 'interrupt-names': ['tx_ts0', 'tx_ts1'], 'ethernet-ports': {'#address-cells': [[1]], '#size-cells': [[0]], 'port@0': {'reg': [[0]], 'phy-handle': [[4294967295]], 'phy-mode': ['rgmii-rxid'], 'interrupts-extended': [[4294967295, 24]], 'ti,syscon-rgmii-delay': [[4294967295, 16672]], 'local-mac-address': [[0, 0, 0, 0, 0, 0]]}, 'port@1': {'reg': [[1]], 'phy-handle': [[4294967295]], 'phy-mode': ['rgmii-rxid'], 'interrupts-extended': [[4294967295, 25]], 'ti,syscon-rgmii-delay': [[4294967295, 16676]], 'local-mac-address': [[0, 0, 0, 0, 0, 0]]}}, '$nodename': ['pruss2_eth']} From schema: /builds/robherring/linux-dt-review/Documentation/devicetree/bindings/net/ti,icssg-prueth.yaml /builds/robherring/linux-dt-review/Documentation/devicetree/bindings/net/ti,icssg-prueth.example.dtb: pruss2_eth: Unevaluated properties are not allowed ('firmware-name', 'ti,prus', 'ti,pruss-gp-mux-sel' were unexpected) From schema: /builds/robherring/linux-dt-review/Documentation/devicetree/bindings/net/ti,icssg-prueth.yaml doc reference errors (make refcheckdocs): See https://patchwork.ozlabs.org/patch/ This check can fail if there are any dependencies. The base for a patch series is generally the most recent rc1. If you already ran 'make dt_binding_check' and didn't see the above error(s), then make sure 'yamllint' is installed and dt-schema is up to date: pip3 install dtschema --upgrade Please check and re-submit.
