Please excuse for the possible duplication, resending the patches including DT mailing list and maintainers in the distribution list. This work is largely based on the previous work by Bjorn Andersson ([1]) Changes since v1 (mostly based on Kondrad's review): - Also disabled dsi0/dsi0 phy in sdm630.dtsi - Removed the clock from BAM DMA devices rather than disabling them completely - Replaced numbers with symbolic names for interconnects in sdm630.dtsi - Switched to "qcom,sda660" as a fallback compatible string - Added dt-bindings for the qcom,sda660 compat - Removed extra nesting level from the adsp firmware path - Replaced numbers with proper symbolic names in the board file - Added chassis-type property - Changed the order of blsp entries in the board file - Removed spurious newlines - Changed the order of regulator properties - Changed the DSI data-lines to list all four lanes. Still use just three lanes for the adv bridge (and describe the reason in the comment) Changes since Bjorn's v2: - Disable dsi1, dsi1 phy, GPU by default in sdm660.dtsi/sdm630.dtsi - Fix qusb2phy ref clock - Added USB2 host support to sdm630.dtsi - Renamed DTS to follow SoC-vendor-board pattern - Fixed vph_pwr voltage - Removed extra/unrelated comments - Added keys, USB2, USB3, - Added configuration for the attached HDMI bridge - Enabled MDP, MDSS and DSI0/DSI0 PHY devices - Removed uart pinctrl and /reserved-mem nodes (present in main dtsi file) - Added card detection for the SDCC2 - Disabled BLSP BAM DMA devices, they make the board reset during boot [1] https://lore.kernel.org/linux-arm-msm/20210825221110.1498718-1-bjorn.andersson@xxxxxxxxxx/#t Dmitry Baryshkov (8): arm64: dts: qcom: sdm660: disable dsi1/dsi1_phy by default arm64: dts: qcom: sdm630: disable dsi1/dsi1_phy by default arm64: dts: qcom: sdm630: disable GPU by default arm64: dts: qcom: sdm630: fix the qusb2phy ref clock arm64: dts: qcom: sdm630: add second (HS) USB host support arm64: dts: qcom: sdm630: use defined symbols for interconnects arm64: dts: qcom: sdm660: Add initial Inforce IFC6560 board support dt-bindings: arm: qcom: document sda660 SoC and ifc6560 board .../devicetree/bindings/arm/qcom.yaml | 6 + arch/arm64/boot/dts/qcom/Makefile | 1 + .../boot/dts/qcom/sda660-inforce-ifc6560.dts | 459 ++++++++++++++++++ arch/arm64/boot/dts/qcom/sdm630.dtsi | 85 +++- arch/arm64/boot/dts/qcom/sdm660.dtsi | 3 + 5 files changed, 542 insertions(+), 12 deletions(-) create mode 100644 arch/arm64/boot/dts/qcom/sda660-inforce-ifc6560.dts -- 2.35.1
