1.Add PWM node for X1830 SoC from Ingenic. 2.Add SSI nodes for X1000 SoC and X1830 SoC from Ingenic. 3.Refresh SSI related nodes in CU1000-Neo and CU1830-Neo. 4.The X1830 SoC used by the CU1830-Neo and the X1000 SoC used by the CU1000-Neo are both single-core processors, therefore the "OST_CLK_PERCPU_TIMER" ABI should not be used in the OST nodes of the CU1830-Neo and CU1000-Neo, it is just a coincidence that there is no problem now. So replace the misused "OST_CLK_PERCPU_TIMER" ABI with the correct "OST_CLK_EVENT_TIMER" ABI. 5.Refresh the defconfig files of the CU1000-Neo board and the CU1830-Neo board, remove the selection of SPI-GPIO, and add the selection of SSI. 周琰杰 (Zhou Yanjie) (3): MIPS: Ingenic: Add PWM nodes for X1830. MIPS: Ingenic: Refresh device tree for Ingenic SoCs and boards. MIPS: Ingenic: Refresh defconfig for CU1000-Neo and CU1830-Neo. arch/mips/boot/dts/ingenic/cu1000-neo.dts | 77 ++++++++++++++++--------------- arch/mips/boot/dts/ingenic/cu1830-neo.dts | 76 +++++++++++++++--------------- arch/mips/boot/dts/ingenic/x1000.dtsi | 20 ++++++++ arch/mips/boot/dts/ingenic/x1830.dtsi | 53 +++++++++++++++++++++ arch/mips/configs/cu1000-neo_defconfig | 2 +- arch/mips/configs/cu1830-neo_defconfig | 2 +- 6 files changed, 154 insertions(+), 76 deletions(-) -- 2.7.4
