Rename the temperature sensor nodes to use "temp-sensor" which matches
their device class instead of IC specific naming.
Remove the status = "okay" which is not required as its default anyway.
Signed-off-by: Robert Marko <robert.marko@xxxxxxxxxx>
---
arch/arm64/boot/dts/marvell/armada-3720-uDPU.dts | 6 ++----
1 file changed, 2 insertions(+), 4 deletions(-)
diff --git a/arch/arm64/boot/dts/marvell/armada-3720-uDPU.dts b/arch/arm64/boot/dts/marvell/armada-3720-uDPU.dts
index b89c7455612d..f21a855fc608 100644
--- a/arch/arm64/boot/dts/marvell/armada-3720-uDPU.dts
+++ b/arch/arm64/boot/dts/marvell/armada-3720-uDPU.dts
@@ -152,14 +152,12 @@ &i2c1 {
scl-gpios = <&gpionb 2 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
sda-gpios = <&gpionb 3 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>;
- nct375@48 {
- status = "okay";
+ temp-sensor@48 {
compatible = "ti,tmp75c";
reg = <0x48>;
};
- nct375@49 {
- status = "okay";
+ temp-sensor@49 {
compatible = "ti,tmp75c";
reg = <0x49>;
};
--
2.36.1
