On Fri, Apr 29, 2022 at 8:38 AM Peter Geis <pgwipeout@xxxxxxxxx> wrote: > > This series enables the DesignWare based PCIe controller on the rk356x > series of chips. We drop the fallback to the core driver due to > compatibility issues. We reset the PCIe controller at driver probe to > prevent issues in the future when firmware / kexec leaves the controller > in an unknown state. We add support for legacy interrupts for cards that > lack MSI support (which is partially broken currently). We then add the > device tree nodes to enable PCIe on the Quartz64 Model A. Good Evening, Just a gentle ping to see if there's anything outstanding here. Very Respectfully, Peter Geis > > Patch 1 drops the snps,dw,pcie fallback from the dt-binding > Patch 2 resets the PCIe controller to prevent configuration bugs > Patch 3 adds legacy interrupt support to the driver > Patch 4 adds the device tree binding to the rk356x.dtsi > Patch 5 enables the PCIe controller on the Quartz64-A > > Changelog: > v9: > - move reset_control_assert out of rockchip_pcie_resource_get > - fix various formatting mistakes > - fix a checkpatch warning > > v8: > - add core reset patch > - simplify IRQ enable/disable functions > - drop spinlock > - only enable/disable IRQ requested > - only pass the IRQ register bits used to irq functions > > v7: > - drop assigned-clocks > > v6: > - fix a ranges issue > - point to GIC instead of ITS > > v5: > - fix incorrect series (apologies for the v4 spam) > > v4: > - drop the ITS modification, poor compatibility is better than > completely broken > > v3: > - drop select node from dt-binding > - convert to for_each_set_bit > - convert to generic_handle_domain_irq > - drop unncessary dev_err > - reorder irq_chip items > - change to level_irq > - install the handler after initializing the domain > > v2: > - Define PCIE_CLIENT_INTR_STATUS_LEGACY > - Fix PCIE_LEGACY_INT_ENABLE to only enable the RC interrupts > - Add legacy interrupt enable/disable support > > > Peter Geis (5): > dt-bindings: PCI: Remove fallback from Rockchip DesignWare binding > PCI: rockchip-dwc: Reset core at driver probe > PCI: rockchip-dwc: Add legacy interrupt support > arm64: dts: rockchip: Add rk3568 PCIe2x1 controller > arm64: dts: rockchip: Enable PCIe controller on quartz64-a > > .../bindings/pci/rockchip-dw-pcie.yaml | 12 +- > .../boot/dts/rockchip/rk3566-quartz64-a.dts | 34 +++++ > arch/arm64/boot/dts/rockchip/rk356x.dtsi | 52 ++++++++ > drivers/pci/controller/dwc/pcie-dw-rockchip.c | 119 +++++++++++++++--- > 4 files changed, 191 insertions(+), 26 deletions(-) > > -- > 2.25.1 >
