Add missing nodes for the flexcom blocks and a node for the SGPIO block. Then add basic support for the Kontron KSwitch D10. The first submission of this patchset was a long time ago. Since then networking matured and is now working. Thus this now also contains patches for all the networking related nodes and enables them on the Kontron D10 switch. changes since v3: - basic d10 switch support dropped the i2c mux and added a dedicated bus for the second SFP cage. - new patch to add the hwmon node - new patches to add the network related nodes and to enable the nodes on the d10 switch changes since v2: - add second kontron board variant and moved common stuff into a new dtsi - moved the uart/i2c nodes inside of the flexcom node - moved sgpio child nodes inside of the sgpio node changes since v1: - fixed indendation - keep compatible, reg first, move #address-cells and #size-cells towards the end Michael Walle (13): ARM: dts: lan966x: swap dma channels for crypto node ARM: dts: lan966x: add sgpio node ARM: dts: lan966x: add missing uart DMA channel ARM: dts: lan966x: add all flexcom usart nodes ARM: dts: lan966x: add flexcom SPI nodes ARM: dts: lan966x: add flexcom I2C nodes ARM: dts: lan966x: add basic Kontron KSwitch D10 support ARM: dts: lan966x: add hwmon node ARM: dts: lan966x: add MIIM nodes ARM: dts: lan966x: add reset switch reset node ARM: dts: lan966x: add serdes node ARM: dts: lan966x: add switch node ARM: dts: kswitch-d10: enable networking arch/arm/boot/dts/Makefile | 4 +- ...lan966x-kontron-kswitch-d10-mmt-6g-2gs.dts | 94 +++++ .../lan966x-kontron-kswitch-d10-mmt-8g.dts | 39 ++ .../dts/lan966x-kontron-kswitch-d10-mmt.dtsi | 190 ++++++++++ arch/arm/boot/dts/lan966x.dtsi | 353 +++++++++++++++++- 5 files changed, 676 insertions(+), 4 deletions(-) create mode 100644 arch/arm/boot/dts/lan966x-kontron-kswitch-d10-mmt-6g-2gs.dts create mode 100644 arch/arm/boot/dts/lan966x-kontron-kswitch-d10-mmt-8g.dts create mode 100644 arch/arm/boot/dts/lan966x-kontron-kswitch-d10-mmt.dtsi -- 2.30.2
