Hi,
you're right, reset is already optional...
idk why it was failing before the patch...i guess i had always defined the reset in dts on switch-side and dropped it same time with this patch.
Reset on both nodes (gmac+switch) blocks in switch driver because of exclusive (error message "could not get our reset line") and after dropping the reset on gmac-side the mdio-bus does not come up after switch driver resets gmac+switch (in loop with edefer).
> Gesendet: Mittwoch, 27. April 2022 um 01:57 Uhr
> Von: "Vladimir Oltean" <olteanv@xxxxxxxxx>
> On Tue, Apr 26, 2022 at 03:49:22PM +0200, Frank Wunderlich wrote:
> > From: Frank Wunderlich <frank-w@xxxxxxxxxxxxxxx>
> >
> > Currently a reset line is required, but on BPI-R2-Pro board
> > this reset is shared with the gmac and prevents the switch to
> > be initialized because mdio is not ready fast enough after
> > the reset.
> >
> > So make the reset optional to allow shared reset lines.
>
> What does it mean "to allow shared reset lines"? Allow as in "allow them
> to sit there, unused"?
for switch part unused right, but reset-line is used by gmac. If switch does the reset, it resets the gmac too and so the mdio goes down. It took longer to get up than the wait-poll after the reset and so i got mdio read errors.
> > - } else {
> > + } else if (priv->reset) {
>
> I don't really understand this patch. gpiod_set_value_cansleep() can
> tolerate NULL GPIO descriptors.
had not looked for NULL-tolerance, so i precautionary added the check.
> > gpiod_set_value_cansleep(priv->reset, 0);
> > usleep_range(1000, 1100);
> > gpiod_set_value_cansleep(priv->reset, 1);
> > @@ -3272,8 +3272,7 @@ mt7530_probe(struct mdio_device *mdiodev)
> > priv->reset = devm_gpiod_get_optional(&mdiodev->dev, "reset",
> > GPIOD_OUT_LOW);
> > if (IS_ERR(priv->reset)) {
> > - dev_err(&mdiodev->dev, "Couldn't get our reset line\n");
> > - return PTR_ERR(priv->reset);
> > + dev_warn(&mdiodev->dev, "Couldn't get our reset line\n");
>
> I certainly don't understand why you're suppressing the pointer-encoded
> errors here. The function used is devm_gpiod_get_optional(), which
> returns NULL for a missing reset-gpios, not IS_ERR(something). The
> IS_ERR(something) is actually important to not ignore, maybe it's
> IS_ERR(-EPROBE_DEFER). And this change breaks waiting for the descriptor
> to become available.
you're right...the intention was to not leave the probe function if not reset was defined...but yes, devm_gpiod_get_optional is called so reset is already optional.
> So what doesn't work without this patch, exactly?
reverted the Patch in my repo and it is still working :)
just ignore it. something went wrong during my tests...
sorry for the inconvenience.
regards Frank
