[RFC PATCH 12/16] drm/rockchip: ebc: Add support for direct mode

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Currently, 3-window mode causes some artifacting. Until the cause is
determined, provide an option to use direct mode instead. Direct mode
does the waveform lookups in software, so it has much higher CPU usage.
This limits the frame rate below the panel's ideal 85 Hz, so it leads to
slightly lower brightness accuracy. On the other hand, it doesn't leave
random lines all over the screen.

Signed-off-by: Samuel Holland <samuel@xxxxxxxxxxxx>
---

 drivers/gpu/drm/rockchip/rockchip_ebc.c | 97 ++++++++++++++++++++++---
 1 file changed, 88 insertions(+), 9 deletions(-)

diff --git a/drivers/gpu/drm/rockchip/rockchip_ebc.c b/drivers/gpu/drm/rockchip/rockchip_ebc.c
index dcd8c8e8208e..93d689ff0933 100644
--- a/drivers/gpu/drm/rockchip/rockchip_ebc.c
+++ b/drivers/gpu/drm/rockchip/rockchip_ebc.c
@@ -162,6 +162,10 @@ static bool diff_mode = true;
 module_param(diff_mode, bool, 0644);
 MODULE_PARM_DESC(diff_mode, "only compute waveforms for changed pixels");
 
+static bool direct_mode = true;
+module_param(direct_mode, bool, 0444);
+MODULE_PARM_DESC(direct_mode, "compute waveforms in software (software LUT)");
+
 static bool skip_reset;
 module_param(skip_reset, bool, 0444);
 MODULE_PARM_DESC(skip_reset, "skip the initial display reset");
@@ -370,6 +374,59 @@ static bool rockchip_ebc_schedule_area(struct list_head *areas,
 	return true;
 }
 
+static void rockchip_ebc_blit_direct(const struct rockchip_ebc_ctx *ctx,
+				     u8 *dst, u8 phase,
+				     const struct drm_epd_lut *lut,
+				     const struct drm_rect *clip)
+{
+	const u32 *phase_lut = (const u32 *)lut->buf + 16 * phase;
+	unsigned int dst_pitch = ctx->phase_pitch / 4;
+	unsigned int src_pitch = ctx->gray4_pitch;
+	unsigned int x, y;
+	u8 *dst_line;
+	u32 src_line;
+
+	dst_line = dst + clip->y1 * dst_pitch + clip->x1 / 4;
+	src_line = clip->y1 * src_pitch + clip->x1 / 2;
+
+	for (y = clip->y1; y < clip->y2; y++) {
+		u32 src_offset = src_line;
+		u8 *dbuf = dst_line;
+
+		for (x = clip->x1; x < clip->x2; x += 4) {
+			u8 prev0 = ctx->prev[src_offset];
+			u8 next0 = ctx->next[src_offset++];
+			u8 prev1 = ctx->prev[src_offset];
+			u8 next1 = ctx->next[src_offset++];
+
+			/*
+			 * The LUT is 256 phases * 16 next * 16 previous levels.
+			 * Each value is two bits, so the last dimension neatly
+			 * fits in a 32-bit word.
+			 */
+			u8 data = ((phase_lut[next0 & 0xf] >> ((prev0 & 0xf) << 1)) & 0x3) << 0 |
+				  ((phase_lut[next0 >>  4] >> ((prev0 >>  4) << 1)) & 0x3) << 2 |
+				  ((phase_lut[next1 & 0xf] >> ((prev1 & 0xf) << 1)) & 0x3) << 4 |
+				  ((phase_lut[next1 >>  4] >> ((prev1 >>  4) << 1)) & 0x3) << 6;
+
+			/* Diff mode ignores pixels that did not change brightness. */
+			if (diff_mode) {
+				u8 mask = ((next0 ^ prev0) & 0x0f ? 0x03 : 0) |
+					  ((next0 ^ prev0) & 0xf0 ? 0x0c : 0) |
+					  ((next1 ^ prev1) & 0x0f ? 0x30 : 0) |
+					  ((next1 ^ prev1) & 0xf0 ? 0xc0 : 0);
+
+				data &= mask;
+			}
+
+			*dbuf++ = data;
+		}
+
+		dst_line += dst_pitch;
+		src_line += src_pitch;
+	}
+}
+
 static void rockchip_ebc_blit_phase(const struct rockchip_ebc_ctx *ctx,
 				    u8 *dst, u8 phase,
 				    const struct drm_rect *clip)
@@ -472,8 +529,13 @@ static void rockchip_ebc_partial_refresh(struct rockchip_ebc *ebc,
 			 * be neutral for every waveform.
 			 */
 			phase = frame_delta >= last_phase ? 0xff : frame_delta;
-			rockchip_ebc_blit_phase(ctx, phase_buffer, phase,
-						&area->clip);
+			if (direct_mode)
+				rockchip_ebc_blit_direct(ctx, phase_buffer,
+							 phase, &ebc->lut,
+							 &area->clip);
+			else
+				rockchip_ebc_blit_phase(ctx, phase_buffer,
+							phase, &area->clip);
 
 			/*
 			 * Copy ctx->next to ctx->prev after the last phase.
@@ -513,7 +575,8 @@ static void rockchip_ebc_partial_refresh(struct rockchip_ebc *ebc,
 		if (list_empty(&areas))
 			break;
 
-		regmap_write(ebc->regmap, EBC_WIN_MST2,
+		regmap_write(ebc->regmap,
+			     direct_mode ? EBC_WIN_MST0 : EBC_WIN_MST2,
 			     phase_handle);
 		regmap_write(ebc->regmap, EBC_CONFIG_DONE,
 			     EBC_CONFIG_DONE_REG_CONFIG_DONE);
@@ -581,10 +644,12 @@ static void rockchip_ebc_refresh(struct rockchip_ebc *ebc,
 	/*
 	 * The hardware has a separate bit for each mode, with some priority
 	 * scheme between them. For clarity, only set one bit at a time.
+	 *
+	 * NOTE: In direct mode, no mode bits are set.
 	 */
 	if (global_refresh) {
 		dsp_ctrl |= EBC_DSP_CTRL_DSP_LUT_MODE;
-	} else {
+	} else if (!direct_mode) {
 		epd_ctrl |= EBC_EPD_CTRL_DSP_THREE_WIN_MODE;
 		if (diff_mode)
 			dsp_ctrl |= EBC_DSP_CTRL_DSP_DIFF_MODE;
@@ -647,8 +712,12 @@ static int rockchip_ebc_refresh_thread(void *data)
 		 */
 		memset(ctx->prev, 0xff, ctx->gray4_size);
 		memset(ctx->next, 0xff, ctx->gray4_size);
-		memset(ctx->phase[0], 0xff, ctx->phase_size);
-		memset(ctx->phase[1], 0xff, ctx->phase_size);
+		/*
+		 * NOTE: In direct mode, the phase buffers are repurposed for
+		 * source driver polarity data, where the no-op value is 0.
+		 */
+		memset(ctx->phase[0], direct_mode ? 0 : 0xff, ctx->phase_size);
+		memset(ctx->phase[1], direct_mode ? 0 : 0xff, ctx->phase_size);
 
 		/*
 		 * LUTs use both the old and the new pixel values as inputs.
@@ -1048,12 +1117,22 @@ static void rockchip_ebc_plane_atomic_update(struct drm_plane *plane,
 		/* Convert from plane coordinates to CRTC coordinates. */
 		drm_rect_translate(dst_clip, translate_x, translate_y);
 
-		/* Adjust the clips to always process full bytes (2 pixels). */
-		adjust = dst_clip->x1 & 1;
+		/*
+		 * Adjust the clips to always process full bytes (2 pixels).
+		 *
+		 * NOTE: in direct mode, the minimum block size is 4 pixels.
+		 */
+		if (direct_mode)
+			adjust = dst_clip->x1 & 3;
+		else
+			adjust = dst_clip->x1 & 1;
 		dst_clip->x1 -= adjust;
 		src_clip.x1  -= adjust;
 
-		adjust = dst_clip->x2 & 1;
+		if (direct_mode)
+			adjust = ((dst_clip->x2 + 3) ^ 3) & 3;
+		else
+			adjust = dst_clip->x2 & 1;
 		dst_clip->x2 += adjust;
 		src_clip.x2  += adjust;
 
-- 
2.35.1




[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux