On 13/04/2022 14:56, Tommaso Merciai wrote:
> Add pwm1/backlight support nodes for imx8mm_evk board.
> Align with u-boot dts
>
Thank you for your patch. There is something to discuss/improve.
>
> diff --git a/arch/arm64/boot/dts/freescale/imx8mm-evk.dtsi b/arch/arm64/boot/dts/freescale/imx8mm-evk.dtsi
> index 6d67df7692f1..4c18f8fcd377 100644
> --- a/arch/arm64/boot/dts/freescale/imx8mm-evk.dtsi
> +++ b/arch/arm64/boot/dts/freescale/imx8mm-evk.dtsi
> @@ -59,6 +59,15 @@ reg_usdhc2_vmmc: regulator-usdhc2 {
> enable-active-high;
> };
>
> + backlight: backlight {
> + status = "okay";
All nodes have status=okay by default, so no need for this.
> + compatible = "pwm-backlight";
> + pwms = <&pwm1 0 5000000>;
> + brightness-levels = <0 255>;
> + num-interpolated-steps = <255>;
> + default-brightness-level = <250>;
> + };
> +
> ir-receiver {
> compatible = "gpio-ir-receiver";
> gpios = <&gpio1 13 GPIO_ACTIVE_LOW>;
> @@ -395,6 +404,12 @@ &wdog1 {
> status = "okay";
> };
>
> +&pwm1 {
> + pinctrl-names = "default";
> + pinctrl-0 = <&pinctrl_backlight>;
> + status = "okay";
This is needed if the node was disabled in DTSI (I did not check it).
Best regards,
Krzysztof
