Re: [RFC 4/4] ARM: shmobile: r8a7790: adapt DTS for I2C slave support

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 




Am Freitag, 12. September 2014, 10:33:48 schrieb Wolfram Sang:
> > > Why do you want DT to be involved at all?
> > 
> > Imagine a device which supports both, slave or master mode. The driver
> > needs to know in which mode it should operate. This cannot be hard coded,
> > because on different boards, different modes can be used.
> 
> Okay, it sounds weird to me that a device is not able to switch between
> master and slave, but if you say so. Also, solving this issue would also
> handle potential weird IP blocks which can be slave only, right?

I didn't said device. I meant the driver (software) needs to know if which 
mode to operate the device. DT has to provide just enough information to 
select the right mode depending on the board implementation.

> What if you use two different adapter drivers or compatibles? One for
> master-mode, one for slave-mode (slave could leave algo->master_xfer
> empty, so the slave mode driver cannot send packets). I'm brainstorming
> here, so while it should work IMO I will probably need a second thought.
> 
> So, in the DT you would have a block registering the I2C slave core
> which binds to a simple driver providing reg_slave/unreg_slave and
> pass on the slave-event. Then you could instantiate slave clients as
> said before.
> 
> Maybe we need a real world example?

ok, take our embedded controller driver (in staging/nvec) as an example. It's 
basicly an MFD connecting keyboard, mouse, power, gpio, and some other stuff 
to the soc. The MFD operates in master mode while the SOC is the I2C slave. 
Theoretically, these roles could also switch (but that's not defined in the 
nvec protocol).

So the i2c client driver sits in between the adapter (in slave or master mode) 
and the the MFD children (keyboard, mouse, ...) and provides read/write/cb 
functions (nvec uses a side channel gpio to be able to initiate writes on its 
own) to its children. The MFD children don't care about how the i2c 
communication is done, but the client driver needs to decide in which mode it 
should talk to the EC. If this is not autodetectable, the mode needs to be 
provided by the device tree.

In this case you cannot use separate drivers for master and slave mode (or you 
would need another layer to hide the driver multiplexing).

> > The point is, that if we define a dt binding for master device on slave
> > adapters it will be there forever. So even if it makes no sense for the
> > example eeprom simulator (or even our embedded controller), it may make
> > sense for other or future devices.
> 
> I don't know what you mean here. Again, an example might help?

I just wanted to say that the discussion here should find a *generic* way to 
distinguish slave and master clients on the i2c bus by using a proper DT 
binding.

Marc

Attachment: signature.asc
Description: This is a digitally signed message part.


[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]
  Powered by Linux