On 2022-04-01 05:48:10, Joel Selvaraj wrote:
> Xiaomi Poco F1 uses the QCOM WLED driver for backlight control.
> Enable and link it to the panel to use it.
>
> Signed-off-by: Joel Selvaraj <jo@xxxxxxxxxxx>
Reviewed-by: Marijn Suijten <marijn.suijten@xxxxxxxxxxxxxx>
> ---
> Changes in v2:
> - Remove qcom,enabled-strings property as either it or qcom,num-strings
> should be present. qcom,num-strings is specified and sufficient.
> (Marijn Suijten's Suggestion)
Thanks :)
> arch/arm64/boot/dts/qcom/sdm845-xiaomi-beryllium.dts | 12 ++++++++++++
> 1 file changed, 12 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/qcom/sdm845-xiaomi-beryllium.dts b/arch/arm64/boot/dts/qcom/sdm845-xiaomi-beryllium.dts
> index 798fc72578a7..d88dc07205f7 100644
> --- a/arch/arm64/boot/dts/qcom/sdm845-xiaomi-beryllium.dts
> +++ b/arch/arm64/boot/dts/qcom/sdm845-xiaomi-beryllium.dts
> @@ -231,6 +231,7 @@ panel@0 {
> #address-cells = <1>;
> #size-cells = <0>;
>
> + backlight = <&pmi8998_wled>;
> reset-gpios = <&tlmm 6 GPIO_ACTIVE_LOW>;
>
> port {
> @@ -314,6 +315,17 @@ vol_up_pin_a: vol-up-active {
> };
> };
>
> +&pmi8998_wled {
> + status = "okay";
> + qcom,current-boost-limit = <970>;
> + qcom,ovp-millivolt = <29600>;
> + qcom,current-limit-microamp = <20000>;
> + qcom,num-strings = <2>;
> + qcom,switching-freq = <600>;
> + qcom,external-pfet;
> + qcom,cabc;
Unlike the number of connected strings and configured ovp/current
limits, aren't external-pfet (and probably switching-freq, perhaps CABC)
hardware features that are common across all users of `pmi8998`?
- Marijn
> +};
> +
> &pm8998_pon {
> resin {
> compatible = "qcom,pm8941-resin";
> --
> 2.35.1
>
