On 10:33-20220401, Vignesh Raghavendra wrote:
> Hi Rahul,
>
> On 31/03/22 8:00 pm, Rahul T R wrote:
> > From: Tomi Valkeinen <tomi.valkeinen@xxxxxx>
> >
> > Add the endpoint nodes to describe connection from
> > DSS => MHDP => DisplayPort connector.
> > Also add the phy link node and required pinmux nodes
> > for hotplug.
> >
> > Signed-off-by: Tomi Valkeinen <tomi.valkeinen@xxxxxx>
> > Signed-off-by: Rahul T R <r-ravikumar@xxxxxx>
> > ---
> > .../dts/ti/k3-j721e-common-proc-board.dts | 78 ++++++++++++++++++-
> > 1 file changed, 74 insertions(+), 4 deletions(-)
> >
> > diff --git a/arch/arm64/boot/dts/ti/k3-j721e-common-proc-board.dts b/arch/arm64/boot/dts/ti/k3-j721e-common-proc-board.dts
> > index f5ca8e26ed99..8ddc0d3bd058 100644
> > --- a/arch/arm64/boot/dts/ti/k3-j721e-common-proc-board.dts
> > +++ b/arch/arm64/boot/dts/ti/k3-j721e-common-proc-board.dts
> > @@ -148,6 +148,28 @@
> > pinctrl-0 = <&main_mcan2_gpio_pins_default>;
> > standby-gpios = <&main_gpio0 127 GPIO_ACTIVE_HIGH>;
> > };
> > +
> > + dp_pwr_3v3: fixedregulator-dp-prw {
>
> Please use standard node name: regulator-X as per DT spec [1]
>
>
> [1]
> https://github.com/devicetree-org/devicetree-specification/releases/tag/v0.3
>
> > + compatible = "regulator-fixed";
> > + regulator-name = "dp-pwr";
> > + regulator-min-microvolt = <3300000>;
> > + regulator-max-microvolt = <3300000>;
> > + gpio = <&exp4 0 0>; /* P0 - DP0_PWR_SW_EN */
>
> Please use GPIO_ACTIVE_* macros as appropriate.
Thanks Vignesh,
Will address the review comments in the respin
Regards
Rahul T R
>
> > + enable-active-high;
> > + };
> > +
> [...]
