From: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxxxxx> Typical GPIO lines like enable, powerdown, reset or wakeup are not documented as common, which leads to new variations of these (e.g. pwdn-gpios). Add a common schema which serves also as a documentation for preferred naming. Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxxxxx> --- Changes since v1: 1. Select-true, add maxItems and description for each entry (Rob). 2. Mention ACTIVE_LOW in bindings description (Linus). 3. Add allOf for pwrseq reset-gpios case. --- .../bindings/gpio/gpio-consumer-common.yaml | 64 +++++++++++++++++++ 1 file changed, 64 insertions(+) create mode 100644 Documentation/devicetree/bindings/gpio/gpio-consumer-common.yaml diff --git a/Documentation/devicetree/bindings/gpio/gpio-consumer-common.yaml b/Documentation/devicetree/bindings/gpio/gpio-consumer-common.yaml new file mode 100644 index 000000000000..40d0be31e200 --- /dev/null +++ b/Documentation/devicetree/bindings/gpio/gpio-consumer-common.yaml @@ -0,0 +1,64 @@ +# SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause +%YAML 1.2 +--- +$id: http://devicetree.org/schemas/gpio/gpio-consumer-common.yaml# +$schema: http://devicetree.org/meta-schemas/core.yaml# + +title: Common GPIO lines + +maintainers: + - Bartosz Golaszewski <brgl@xxxxxxxx> + - Linus Walleij <linus.walleij@xxxxxxxxxx> + +description: + Pay attention to using proper GPIO flag (e.g. GPIO_ACTIVE_LOW) for the GPIOs + using inverted signal (e.g. RESETN). + +select: true + +properties: + enable-gpios: + maxItems: 1 + description: + GPIO connected to the enable control pin. + + reset-gpios: + description: + GPIO (or GPIOs for power sequence) connected to the device reset pin + (e.g. RESET or RESETN). + + powerdown-gpios: + maxItems: 1 + description: + GPIO connected to the power down pin (hardware power down or power cut, + e.g. PD or PWDN). + + pwdn-gpios: + maxItems: 1 + description: Use powerdown-gpios + deprecated: true + + wakeup-gpios: + maxItems: 1 + description: + GPIO connected to the pin waking up the device from suspend or other + power-saving modes. + +allOf: + - if: + properties: + compatible: + contains: + enum: + - mmc-pwrseq-simple + then: + properties: + reset-gpios: + minItems: 1 + maxItems: 32 + else: + properties: + reset-gpios: + maxItems: 1 + +additionalProperties: true -- 2.32.0
