> Wiadomość napisana przez Sascha Hauer <s.hauer@xxxxxxxxxxxxxx> w dniu 30.03.2022, o godz. 11:45: > > On Wed, Mar 30, 2022 at 10:41:56AM +0200, piotro.oniszczuk@xxxxxxxxxx wrote: > > Let me rephrase this: The above sets a plane, but it doesn't set a mode > on the crtc. When my system boots up then the output of modetest looks > like this: > > Encoders: > id crtc type possible crtcs possible clones > 68 0 TMDS 0x00000001 0x00000001 > Connectors: > id encoder status name size (mm) modes encoders > 69 0 connected HDMI-A-1 530x300 9 68 > CRTCs: > id fb pos size > 67 0 (0,0) (0x0) > #0 nan 0 0 0 0 0 0 0 0 0 flags: ; type: > > No mode is set on the CRTC and the encoder/connector/crtc are not bound > to each other, consequently the screen is in standby. "modetest -P > 43@67:1920x1080@NV12" doesn't change this, still no mode set. Hence my > question: How did you set a mode initially? Ah ok. I see your point. mode is set by app (player). Sequence was like this: -boot board -start app -on UI select playback -playback has green screen -exit app -run modetest -P 43@67:1920x1080@NV12 (the same green screen like in playback) -run modetest -P 49@67:1920x1080@NV12 (works ok) -run modetest -P 43@67:1920x1080@NV12 (now works ok) > >>> >> >> I'm not sure that above command only sets plane. >> On other SoCs i’m testing it gives expected results: diagonal colored stripes. >> There is single exception: rk356x with vop2 - where screen is green unless i „fix/enable” by playing with plane #69 >> >>> I did with "modetest -s 69@67:1920x1080 -d" and with this it works as >>> expected, I can't reproduce any green screen issue here. >> >> I see you are using plane #69. >> Why not #43? > > I used "modetest -s 69@67:1920x1080 -d" to set a mode. The '69' is the > connector id, not a plane. ack. typo from my side. it was modetest -P 49@67:1920x1080@NV12 > >> Is plane #43 working ok for you? > > Yes. So it looks your testing method of #43 is not meaningful for verifying issue we are discussing here. In my case: 12 SOC (except rk356x VOP2) gives me: -boot board -start app -on UI select playback -playback is ok -exit app -run modetest -P XX@YY:1920x1080@NV12 (diagonal stripes) (XX/YY are plane/connector elected by app: plane@conector with format matching provider format) rk356x with vop2 v9: -boot board -start app -on UI select playback -playback has green screen -exit app -run modetest -P 43@67:1920x1080@NV12 (the same green screen like in playback) -run modetest -P 49@67:1920x1080@NV12 (works ok) -run modetest -P 43@67:1920x1080@NV12 (now works ok)
