[PATCH V2] arm64: dts: qcom: sc7280-idp: Configure cts sleep pinctrl to bias-bus-hold

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



WLAN rail was leaking power during RBSC/sleep even after turning BT off.
Change sleep pinctrl configuration to handle same.

Signed-off-by: Vijaya Krishna Nivarthi <quic_vnivarth@xxxxxxxxxxx>
---
v2: used bias-bus-hold as per review comments
v1: intial patch used bias-disable
---
 arch/arm64/boot/dts/qcom/sc7280-idp.dtsi | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/arch/arm64/boot/dts/qcom/sc7280-idp.dtsi b/arch/arm64/boot/dts/qcom/sc7280-idp.dtsi
index d623d71..80ab2d8 100644
--- a/arch/arm64/boot/dts/qcom/sc7280-idp.dtsi
+++ b/arch/arm64/boot/dts/qcom/sc7280-idp.dtsi
@@ -516,10 +516,10 @@
 		pins = "gpio28";
 		function = "gpio";
 		/*
-		 * Configure a pull-down on CTS to match the pull of
-		 * the Bluetooth module.
+		 * Configure a bus-hold on CTS to lower power usage
+		 * when BT is turned off.
 		 */
-		bias-pull-down;
+		bias-bus-hold;
 	};
 
 	qup_uart7_sleep_rts: qup-uart7-sleep-rts {
-- 
Qualcomm INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum, hosted by the Linux Foundation.




[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux