Re: [PATCH v8 1/3] dt-bindings: mmc: mtk-sd: extend interrupts and pinctrls properties

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Il 22/03/22 02:35, Axe Yang ha scritto:
On Mon, 2022-03-21 at 18:29 -0500, Rob Herring wrote:
On Mon, Mar 21, 2022 at 07:51:32PM +0800, Axe Yang wrote:
Extend interrupts and pinctrls for SDIO wakeup interrupt feature.
This feature allow SDIO devices alarm asynchronous interrupt to
host
even when host stop providing clock to SDIO card. An extra wakeup
interrupt and pinctrl states for SDIO DAT1 pin state switching are
required in this scenario.

Signed-off-by: Axe Yang <axe.yang@xxxxxxxxxxxx>
---
  .../devicetree/bindings/mmc/mtk-sd.yaml       | 23
++++++++++++++++++-
  1 file changed, 22 insertions(+), 1 deletion(-)

diff --git a/Documentation/devicetree/bindings/mmc/mtk-sd.yaml
b/Documentation/devicetree/bindings/mmc/mtk-sd.yaml
index 297ada03e3de..f57774535a1d 100644
--- a/Documentation/devicetree/bindings/mmc/mtk-sd.yaml
+++ b/Documentation/devicetree/bindings/mmc/mtk-sd.yaml
@@ -69,12 +69,23 @@ properties:
        - const: ahb_cg
interrupts:
-    maxItems: 1
+    description:
+      Should at least contain MSDC GIC interrupt. To support SDIO
in-band wakeup, an extended
+      interrupt is required and be configured as wakeup source
irq.
+    minItems: 1
+    maxItems: 2
pinctrl-names:
+    description:
+      Should at least contain default and state_uhs. To support
SDIO in-band wakeup, dat1 pin
+      will be switched between GPIO mode and SDIO DAT1 mode,
state_eint and state_dat1 are
+      mandatory in this scenarios.
+    minItems: 2
      items:
        - const: default
        - const: state_uhs
+      - const: state_eint
+      - const: state_dat1
pinctrl-0:
      description:
@@ -86,6 +97,16 @@ properties:
        should contain uhs mode pin ctrl.
      maxItems: 1
+ pinctrl-2:
+    description:
+      should switch dat1 pin to GPIO mode.
+    maxItems: 1
+
+  pinctrl-3:
+    description:
+      should switch SDIO dat1 pin from GPIO mode back to SDIO
mode.

How is this different than pinctrl-0?

pinctrl-0 contains default settings for all IO pins(CLK/CMD/DAT).
pinctrl-1 contains settings for all IO pins(CLK/CMD/DAT) in UHS mode.
pinctrl-3 is lightweight pinctrl-1, only keep SDIO DAT1 pin function
switch part.


Is there any particular reason why we cannot simply select pinctrl-1 again
instead of pinctrl-3, apart from the virtually not existent overhead of
one more mmio write?

...

Regards,
Axe





[Index of Archives]     [Device Tree Compilter]     [Device Tree Spec]     [Linux Driver Backports]     [Video for Linux]     [Linux USB Devel]     [Linux PCI Devel]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [XFree86]     [Yosemite Backpacking]


  Powered by Linux