Convert the pinctrl ocelot binding to the new YAML format. Pin configuration nodes should have a "-pins" postfix. But unfortunately, there are many device trees which don't follow this. First rename all these nodes and then convert the binding to the YAML format so that the validation will pass. Because there were no maintainers before and there is none in MAINTAINERS I added Alexandre Belloni and Lars Povlsen, juding by the commits - to the binding as maintainers. Please tell me if you disagree. changes since v1: - drop "Device Tree Binding" from the title of the binding - describe reg properties and provide minItems and set it differently depending on the compatible string - skip interrupt description - move required section after patternProperties Michael Walle (8): MIPS: mscc: jaguar2: fix pinctrl nodes MIPS: mscc: ocelot: fix MIIM1 pinctrl node name MIPS: mscc: ocelot: fix PHY interrupt pinctrl node name MIPS: mscc: ocelot: fix load/save GPIO pinctrl name MIPS: mscc: serval: fix pinctrl node names arm64: dts: sparx5: fix pinctrl node names ARM: dts: lan9662-pcb8291: fix pinctrl node name dt-bindings: pinctrl: convert ocelot-pinctrl to YAML format .../bindings/pinctrl/mscc,ocelot-pinctrl.txt | 42 ------- .../bindings/pinctrl/mscc,ocelot-pinctrl.yaml | 108 ++++++++++++++++++ arch/arm/boot/dts/lan966x-pcb8291.dts | 2 +- .../dts/microchip/sparx5_pcb134_board.dtsi | 26 ++--- .../dts/microchip/sparx5_pcb135_board.dtsi | 10 +- arch/mips/boot/dts/mscc/jaguar2_pcb110.dts | 10 +- arch/mips/boot/dts/mscc/jaguar2_pcb111.dts | 10 +- arch/mips/boot/dts/mscc/jaguar2_pcb118.dts | 6 +- arch/mips/boot/dts/mscc/ocelot.dtsi | 4 +- arch/mips/boot/dts/mscc/ocelot_pcb120.dts | 6 +- arch/mips/boot/dts/mscc/serval_common.dtsi | 14 +-- 11 files changed, 152 insertions(+), 86 deletions(-) delete mode 100644 Documentation/devicetree/bindings/pinctrl/mscc,ocelot-pinctrl.txt create mode 100644 Documentation/devicetree/bindings/pinctrl/mscc,ocelot-pinctrl.yaml -- 2.30.2
