On Tue, 15 Mar 2022 at 09:26, Yann Gautier <yann.gautier@xxxxxxxxxxx> wrote: > > On 3/14/22 23:43, Linus Walleij wrote: > > "On Fri, Mar 4, 2022 at 2:52 PM Yann Gautier <yann.gautier@xxxxxxxxxxx> wrote: > > > >> On STMicroelectronics variant of PL18x, the DMA Linked Lists are supported > >> starting from revision v2 of the peripheral. But it has limitations, > >> as all the buffers should be aligned on block size (except the last one). > >> But this cannot be guaranteed with SDIO. We should then have a property > >> to disable the support of LLI. > >> > >> Signed-off-by: Yann Gautier <yann.gautier@xxxxxxxxxxx> > > > > Actually I think this is present also on the ux500 variants. See: > > commit 2253ed4b36dc876d1598c4dab5587e537ec68c34 > > "mmc: mmci: Support any block sizes for ux500v2 and qcom variant" > > > > Spot the variant data "dma_power_of_2". > > > > So whatever property you add > > to the variant data (not in the device tree please) should > > be added to the ux500 variants as well, it will *VERY* likely > > have a problem with LLI elements not being a power of 2 > > as it is the ancestor of later STMicro variants. > > > > It might actually be the reason for some annoying WiFi error > > messages I have seen :/ > > > > Yours, > > Linus Walleij > > Hi Linus, > > The STM32 variant uses an internal DMA, and the DMA functions are in its > dedicated file. So I was planning to do the same as what is done in > meson-gx-mmc.c: using a bounce buffer to copy from/to in case DMA > constraints are not fulfilled. Not sure it can help for Ux500. We already have a bounce buffer in mmci_pio_read(), but we need one in mmc_pio_write() too, which hasn't been implemented yet. > > Ulf, before I send my new series (although it is not ready yet), would > you be OK with the bounce buffer idea? Yes, that works for me. On the other hand, it would be even better if we could specify the buffer limitations per mmc host instance, so upper layers (SDIO func drivers) could conform to these - and use better buffers, to achieve a better performance. > > > Best regards, > Yann Kind regards Uffe
