Hi Horatiu, > > On Tue, Oct 19, 2021 at 01:52:04PM +0200, Horatiu Vultur wrote: > > > Document the lan966x phy reset device driving bindings. > > > It is using register access for the internal PHYs and toggles > > > GPIO for external PHYs. > > > > > > Signed-off-by: Horatiu Vultur <horatiu.vultur@xxxxxxxxxxxxx> > > > --- > > > .../bindings/reset/lan966x-phy,rst.yaml | 53 +++++++++++++++++++ > > > 1 file changed, 53 insertions(+) > > > create mode 100644 Documentation/devicetree/bindings/reset/lan966x-phy,rst.yaml > > > > > > diff --git a/Documentation/devicetree/bindings/reset/lan966x-phy,rst.yaml b/Documentation/devicetree/bindings/reset/lan966x-phy,rst.yaml > > > new file mode 100644 > > > index 000000000000..35a32458cafe > > > --- /dev/null > > > +++ b/Documentation/devicetree/bindings/reset/lan966x-phy,rst.yaml > > > @@ -0,0 +1,53 @@ > > > +# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) > > > +%YAML 1.2 > > > +--- > > > +$id: "http://devicetree.org/schemas/reset/lan966x-phy,rst.yaml#"; > > > +$schema: "http://devicetree.org/meta-schemas/core.yaml#"; > > > + > > > +title: Microchip Lan966x PHY Reset > > > + > > > +maintainers: > > > + - Horatiu Vultur <horatiu.vultur@xxxxxxxxxxxxx> > > > + > > > +description: | > > > + The Microchip Lan966x Switch provides 2 internal PHY which needs to be > > > + released from reset before they can be accessed. Also it might have external > > > + PHYs which requires to toggle a GPIO before the access to the PHYs. I don't think this driver is needed at all. See more below. > > > + external-phy-reset-gpios: > > > + description: used for release of reset of the external PHY > > > + maxItems: 1 > > > > This belongs in the external PHY's node. > > My problem is if I put this in the external PHY's node, once the switch > gets reset it would reset also the GPIO pin and then it can't connect > to the external PHYs anymore. But this will only solve your use case. If there is anything else connected on the GPIO it will be reset, too. So you'd loose GPIO state and you just 'fix' the exernal PHY reset lines here. Fortunately, this is already solved by the shared reset lines. See [1] for my proposal. Once the GPIO controller isn't reset anymore, we can describe the reset line to the external PHYs by using the "reset-gpios" property of the MDIO controller. > The switch will need anyway to call this driver to release the reset of > the internal PHYs, so I was thinking to put also the release of the > external PHYs in the same driver. There is already support for this in the MDIO driver, see [2]. This is already used on the Ocelot series. > Initially we wanted to extend the 'sparx5-switch-reset' driver to do > this but the output of that discussion was to have 2 different drivers, > one for the switch and one for the PHYs. -michael [1] https://lore.kernel.org/linux-devicetree/20220313154640.63813-1-michael@xxxxxxxx/ [2] https://lore.kernel.org/netdev/20220313002153.11280-1-michael@xxxxxxxx/
