Flexcom3 is used as board console serial. There are no pull-ups on these
lines on the board. This means that if a cable is not connected (that has
pull-ups included), stray characters could appear on the console as the
floating pins voltage levels are interpreted as incoming characters.
To avoid this problem, enable the internal pull-ups on these lines.
Signed-off-by: Eugen Hristev <eugen.hristev@xxxxxxxxxxxxx>
---
arch/arm/boot/dts/at91-sama7g5ek.dts | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/arch/arm/boot/dts/at91-sama7g5ek.dts b/arch/arm/boot/dts/at91-sama7g5ek.dts
index 08685a10eda1d..dd047a8523907 100644
--- a/arch/arm/boot/dts/at91-sama7g5ek.dts
+++ b/arch/arm/boot/dts/at91-sama7g5ek.dts
@@ -495,7 +495,7 @@ pinctrl_flx0_default: flx0_default {
pinctrl_flx3_default: flx3_default {
pinmux = <PIN_PD16__FLEXCOM3_IO0>,
<PIN_PD17__FLEXCOM3_IO1>;
- bias-disable;
+ bias-pull-up;
};
pinctrl_flx4_default: flx4_default {
--
2.25.1
