Add a disable_keep_power field in variant_data struct. The
MMC_PM_KEEP_POWER flag will be enabled if disable_keep_power is not set.
It is only set to true for stm32_sdmmc variants.
The issue was seen on STM32MP157C-DK2 board, which embeds a wifi chip.
It doesn't correctly support low power, and we need to unbind the wifi
driver before a suspend sequence. But the wifi chip firmware is then
lost, and the communication with SDIO fails if MMC_PM_KEEP_POWER is
enabled.
The flag can still be enabled through DT property: keep-power-in-suspend.
Signed-off-by: Yann Gautier <yann.gautier@xxxxxxxxxxx>
---
drivers/mmc/host/mmci.c | 5 ++++-
drivers/mmc/host/mmci.h | 1 +
2 files changed, 5 insertions(+), 1 deletion(-)
diff --git a/drivers/mmc/host/mmci.c b/drivers/mmc/host/mmci.c
index 45b8608c935c..0e2f2f5d6a52 100644
--- a/drivers/mmc/host/mmci.c
+++ b/drivers/mmc/host/mmci.c
@@ -274,6 +274,7 @@ static struct variant_data variant_stm32_sdmmc = {
.busy_detect = true,
.busy_detect_flag = MCI_STM32_BUSYD0,
.busy_detect_mask = MCI_STM32_BUSYD0ENDMASK,
+ .disable_keep_power = true,
.init = sdmmc_variant_init,
};
@@ -301,6 +302,7 @@ static struct variant_data variant_stm32_sdmmcv2 = {
.busy_detect = true,
.busy_detect_flag = MCI_STM32_BUSYD0,
.busy_detect_mask = MCI_STM32_BUSYD0ENDMASK,
+ .disable_keep_power = true,
.init = sdmmc_variant_init,
};
@@ -2172,7 +2174,8 @@ static int mmci_probe(struct amba_device *dev,
host->stop_abort.flags = MMC_RSP_R1B | MMC_CMD_AC;
/* We support these PM capabilities. */
- mmc->pm_caps |= MMC_PM_KEEP_POWER;
+ if (!variant->disable_keep_power)
+ mmc->pm_caps |= MMC_PM_KEEP_POWER;
/*
* We can do SGIO
diff --git a/drivers/mmc/host/mmci.h b/drivers/mmc/host/mmci.h
index e1a9b96a3396..2cad1ef9766a 100644
--- a/drivers/mmc/host/mmci.h
+++ b/drivers/mmc/host/mmci.h
@@ -361,6 +361,7 @@ struct variant_data {
u32 opendrain;
u8 dma_lli:1;
u32 stm32_idmabsize_mask;
+ u8 disable_keep_power:1;
void (*init)(struct mmci_host *host);
};
--
2.25.1
